Intelligent AQE-ENV-701-WH Countertop Wash Basin Installation Guide
- June 9, 2024
- Intelligent
Table of Contents
Intelligent AQE-ENV-701-WH Countertop Wash Basin
General Installation
- To the installer: Please read and follow this instruction carefully, as the guarantee is only valid if the product is installed as directed.
- The installation of this Basin requires the preferred previous installation of a suitably constructed countertop.
- Please ensure that the countertop is suitable for the weight allowance of the basin and its components.
- Don’t rush, read the instructions first and run through them before you begin. Keep fittings together to avoid loss.
- Do not over-tighten screws or bolts.
- If the unit is covered with polyethylene protective film, do not remove until installation is complete to grant maximum protection.
- However, remove f ilm where any two surfaces will be in permanent contact.
- Verify that all dimensions on the plan are the same as the ones of the product.
- Please leave this installation manual with the end user once the product has been installed.
TOOLS REQUIRED (Not supplied)
Drill, drill bits & hole saw
-
* Required when drilling a wooden countertop surface, for Marble/Stone countertops please use a specialized cutting company.- Place the basin on the countertop, take notice of the spout length of the mixer so that the distance is correct. Mark around the perimeter of the basin and waste hole.
- Check that the waste provision is in the correct place, and check the bottle trap dimensions to ensure that the distance is achievable
- Drill waste hole allowing for the finished dimensions of the waste outlet. In this instance its 0 75-11 mm, please check your corresponding waste out let product.
- Install the waste assembly into the basin
- If required, place a few dots of silicon on the base of the basin, align, and place in position, allowing the silicon to cure for a few hours.
- Install the bottle trap onto the waste, cut the horizontal pipe to length, and install it into the wall via a waste compression fitting or rubber socket. If required run a small bead of silicon around the perimeter base
Product Aftercare
- We recommend cleaning with a soft damp cloth and mild soap solution.
- Do not use cream cleaners or cleaners containing bleach.
- Do not scrub or scour.
- Do not use abrasive cleaning agents.
- Do not use solvent-based cleaners.
IMPORTANT PLEASE READ
- Remove all packaging and check the product for missing parts or damage before starting installation.
- Any alterations made to this product and fittings may infringe water regulations and invalidate the guarantee.
- The Installation must comply with all Local/National Water Supply Authority
- Regulations/Byelaws and Building and Plumbing Regulations.
- We strongly recommend that your product be installed by a reputable qualified trade’s person.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>