GERMAN BLD-WL45 Cordless Mini Chopper User Manual
- June 9, 2024
- German
Table of Contents
GERMAN BLD-WL45 Cordless Mini Chopper User Manual
Warnings and Safety Precautions
-
Fully charge this product before you use it first time.
-
Make sure the blade unit is installed in place properly and runs smoothly, before any food is put in this product.
-
DO NOT scratch this product with anything sharp.
-
It is strictly prohibited to overload this product.
-
DO NOT heat up this product in a microwave oven or freeze it in a refrigerator, otherwise this product will break. The maximum water temperature for washing and sterilizing this product is 100°C.
-
DO NOT use this product to crush hard food such as coffee beans, beans, rice, ice cubes or frozen food.
-
When this product is working, it’s strictly prohibited to touch any of its detachable parts such as blades, motors, etc., in order to avoid injury or damage to this product.
-
It’s designed that this product won’t work continuously for more than 30 seconds. If you need this product to work again, wait for 2 minutes. If this product has continuously worked for 3 times, with an interval of 2 minutes between each time, wait for 30 minutes before you make it work for the 4th time. This is to protect the product and make sure it lasts long time.
-
The blades are very sharp. DO NOT touch them with naked fingers during
installation, cleaning, etc. Hold the plastic pillar of the blade unit when you are
doing so. -
DO NOT use steel wool, abrasive cleaners or aggressive liquids (such as gasoline or acetone) to clean this product. The bottom of the main body can be quickly
rinsed with clean water at a slanted angle (DO NOT wet the push button part). DO NOT dip the main body in water. -
DO NOT leave any part of this product being washed in the dishwasher.
-
This product should be stored in a place that is not easily accessed by children. DO NOT let persons (including children) who are physically impaired, feel or
mentally impaired, or lack of relevant experience and knowledge use or play with this product. -
This product is only suitable for personal or household use, not for commercial use.
-
WARNING! Be careful not to get cut by the sharp blades when removing food from the product, or when removing the blades for cleaning
Product Structure
Operation Instruction
Note:
- Fully charge this product before using it for the first time. When fully charged, indicator light lights up constant in blue.
- Wash the blade unit, jar lid and glass jar before use.
-
Install the blade unit onto the shaft at the bottom of the jar, then place clean food into the jar (DO NOT fill to above the Max level indicated on the jar).
-
After placing in the food, place on the jar lid, and place on the main unit (align the grooves on the base of the main unit with the ribs on the jar lid). Indicator light blinks in blue for 5 times.
-
Press Push Button to start chopping. If the jar is overfilled, the blades will not turn; if this happens, please take out part of the food then press Push Button again.
Note:- The maximum duration per use is 30 seconds. If user long-presses Push Button for more than 30 seconds, the product will automatically stop after 30 seconds.
- If user requires the food to be chopped even more finely, please wait 2 minutes before long-pressing Push Button again.
-
After chopping, take off the main unit and the jar lid, and carefully remove the blade unit before pouring out the food.
Indicator Lights Explained
Indicator Light | Status |
---|---|
Lights up constant in red | Charging |
Lights up constant in blue | Fully charged |
Blinks in blue for 5 times | Motor and blade engaged |
(When the main unit is properly fitted onto the jar lid)
Blinks alternately in blue and red for
10 times
| Motor and blade disengaged
(When the main unit is lifted off the jar lid)
Lights up in blue| In use (When Push Button is pressed)
Note:
This product is designed to work in short spurts of no more than 30 seconds
each.
If product has worked continuously for 30 seconds, user must wait 2 minutes
before using it again. If product has continuously worked for 3 times (30
seconds each time with 2 minutes rest between each time), wait for 30 minutes
before using it again. This is to protect the motor of the product.
Cleaning and Maintenance
WARNING!
- This product must be unplugged from the power source and blade unit must be detached from the main unit before cleaning and maintenance.
- DO NOT immerse or directly rinse main unit with water.
- Please clean the main unit, blade unit and glass jar promptly after use.
- The bottom of the main body can be quickly rinsed with clean water at a slanted angle (DO NOT wet the push button part), or wiped clean with a warm soft cloth. Glass jar, jar lid and blade unit can be washed with soft cloth and water diluted with detergent. Use warm water for better result.
- The blades are very sharp, DO NOT touch them with your hands. To avoid injury, the water used for washing the blades must be very clear so that you can see the blades clearly.
- DO NOT use abrasive or corrosive cleansers to clean this product.
- DO NOT sterilize this product and its accessories with high heat.
- After cleaning, wipe dry or air dry the main unit and accessories completely (DO NOT touch the blade unit with your hand), reassemble and store away.
- If this product will not be used for an extended period of time, please charge the battery every 3 months, this will help to prolong the battery life.
Troubleshooting
Problem | Indicator Light | Possible Cause | Solution |
---|---|---|---|
Push Button is pressed but product does not start | Indicator light blinks | ||
alternately in red and blue | Main unit is not properly attached to the glass | ||
jar | Attach main unit and glass jar properly | ||
Indicator light lights up in red for 3 seconds | Low battery | Charge the |
battery
Indicator light lights up constant in blue| Motor is damagedor stuck| Turn the
motor axle; if motor still willnot turn, contact German Pool Customer Service
& Repair Centre
Product cannot charge| Indicator light does not light up| Check if the
USBcable is loose| Connect USB cable firmly or replace with a new cable
Motor emits a strange smell when using for the first few times| /| This is a
normal phenomenon| If motor still smells after using for many times, contact
German Pool Customer Service & Repair Centre
Blades will not turn| /| Blades are entangled or jammed by food| Take off the
main unit, take out the food and cut into smaller pieces, or chop the food in
smaller batches
WARNING!
The above are the common fault analysis and troubleshooting methods. For other
problems, please contact German Pool Customer Service & Repair Centre. DO NOT
disassemble and repair this product by yourself.
Technical Specification
Model | BLD-WL45 |
---|---|
Output Voltage | DC 3.7 V |
Output Power | 45 W |
Max. Duration for Each Use | 30 seconds |
Product Dimensions | (H)150 (W)100 (D)100 mm |
Net Weight | 0.62 kg |
- Specification is subject to change without prior notice.
- If there is any inconsistency or ambiguity between the English version and the Chinese version, the Chinese version shall prevail.
- Refer to www.germanpool.com for the most update version of the user manual.
Warranty Terms & Conditions
Under normal operations, the product will gurantee a 1-year full warranty provided by German Pool (effective from the date of purchase).
This warranty is not valid until customer registration information is received by our Service Centre within 10 days of purchase via one of the following means:
-
Visit our VIP App and register online (Scan the QR Code on the left)
-
Visit our VIP App and register online: www.germanpool.com/warranty
-
Complete the attached Warranty Card and mail it back to our Customer Service Centre.
-
Customer who fails to present original purchase invoice will
not be eligible for free warranty service. -
Customer should always follow the operating
instructions. This warranty does not apply to:- labour costs for on-site installation, check-up, repair, replacement of parts and other transportation costs;
- damages caused by accidents of any kind (including material transfer and others);
- operating failures resulting from applying incorrect voltage, improper usage, and unauthorized installations or repairs.
-
This warranty is invalid if:
- the purchase invoice is modified by an unauthorized party;
- the product is used for any commercial or industrial purposes;
- the product is repaired or modified by unauthorized personnel, or unauthorized parts are installed;
- the serial number is modified, damaged or removed from the product.
-
German Pool will, at its discretion, repair or replace any defective part.
-
This warranty will be void if there is any transfer of ownership from the original purchaser.
Customer Service & Repair Centre
Hong Kong
Unit B, G/F, Sunshine Kowloon Bay Cargo Centre, 59 Tai Yip Street, Kowloon
Macau
A, 1 Andar, Mei Kui Kuong Cheong Fase 2, No.515 Avenida Do Conselheiro Borja
Kowloon, Hong Kong
Tel : +852 2333 6249
Fax : +852 2356 9798
Email : repairs@germanpool.com
Macau
Tel : +853 2875 2699
Fax : +853 2875 2661
This warranty is valid only in Hong Kong and Macau