Valerie Objects V9018002 M Ceiling Lamp No. 2 Instruction Manual
- October 27, 2023
- valerie objects
Table of Contents
V9018002 M Ceiling Lamp No. 2
Instruction Manual
V9018002 M Ceiling Lamp No. 2
****| for indoor use only, where direct
contact with water is impossible| the armature can be used in
combination with a dimmer.
consult the sales outlet for the
correct type| protection class 1:
the fitting must be earthed
---|---|---|---
this luminaire was designed to
work only with the indicated
voltage| not to be disposed of with domestic
waste in the rubbish bin, bring it to a
staging area for electrical waste| the maximum wattage indicated in each
lighting unit, for example, must not be exceeded| observe the indicated
minimum
distance between the lamp and
the illuminated materials/objects
safety directions
Please study the instruction manual carefully before installing or using this
product.
Keep this user manual for further reference / two persons are needed for
installation.
- The luminaires may only be installed by authorized and qual ed technicians according to valid regulations for electrical installation.
- Maintenance of the luminaires is limited to their surfaces. During maintenance, no moisture can come into contact with any areas of the terminal connections or voltage control parts.
- Take account of the minimum separation distance from other objects and the room required around the fitting.
- If in any doubt, consult a professional, taking local installation requirements into account. Some countries stipulate that lighting may be installed only by registered installers.
- When replacing a lamp, wait for it to cool, for a minimum of 5 minutes.
- Clean with a clean, dry cloth or brush, use no solvents or abrasives. Avoid dampness on all electrical components.
- Take account of all available technical information.
- If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or his service agent or a similar qual ed person in order to avoid a hazard.
1x ceiling lamp (frame + power cord
+ ceiling pot)| 2x set wall brackets + spacers (wall plugs included)| 1x lamp
shade| 1x Led bulb silvered cap 4W – 350lm
2700 K (dimmable) energy class A+
---|---|---|---
| | |
-
assemble these two parts of the back part
-
drill two holes with the requested diameter (ø 10 mm) for the appropriate wall plugs according to your type of ceiling
-
screw the back part of the wall bracket into (by hand) the wall plug
-
screw carefully the front part of the wall bracket on the back part (by hand) make sure the spacers are in between
-
take care:
– do not screw the wall brackets tight
– align carefully the correct vertical hanging position
– tight both brackets -
installation of the ceiling pot
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>