OSD AUDIO PRE 1 Stereo Pre Amplifier Installation Guide
- June 9, 2024
- OSD AUDIO
Table of Contents
OSD AUDIO PRE 1 Stereo Pre Amplifier
Front Panel Description
- Power ON / OFF
- Microphone Jack Input
- Mic Level Control
- Bass Control: To boost or attenuate low frequency sound.
- Midrange Control: To boost or attenuate midrange frequency sound.
- Treble Control: To boost or attenuate high frequency sound.
- Loudness: To compensate for the non-linear response of the human ear at low volume.
- Balance: Controls the relative volume between the left/right speakers and headphone.
- Master Volume: Adjusts the main output volume level of speakers and headphones.
- Input Selector: Switch between multiple input sources.
- Tape: Input for an analog tape deck
- Mono: Switch between mono or stereo signal
- Low Frequency Filter: Eliminates low frequency distortion from a turntable or warped record.
- Mute: Reduce the volume level by 20dB. Useful when changing records, tapes or changing sources.
Back Panel Description
- Phono Inputs: Connect to Left/Right output from a turntable.
- Aux Input 2: Auxiliary source input.
- Aux Input 1: Auxiliary source input.
- CD/DVD Input: Connect to Left/Right output from a CD or DVD player.
- Tape Play: Connect to a tape decks output jacks.
- Tape Rec: Connect to a tape decks input jacks.
- Output: Used to connect to a signal processing unit, such as a graphic equalizer or can be connected to a power amplifier with higher output power.
- Ground Screw: Connect the ground wire from a turntable here to avoid hum or feedback from the speakers.
- AC Selector : Switch between 110V-220V AC.
- Fuse Holder: Contains primary AC fuse If fuse blows replace only with the same amperage fuse.
- AC Power Cord: Plug the AC cord into a nearby AC outlet or surge protector.
System Diagram
Specifications
I nput Sensitivity/Impedance
Mic
Phono
Tape,Tuner, CD/DVD, Aux
|
0.SV/600 Ohms
3mV/47k Ohms
150mV/47k Ohms
---|---
Output Level/Impedance
Tape Rec
Pre Output| 150mV/100k Ohms
500mV/47k Ohms
Total Harmo n ic D istort ion
Mic
Phono
Tape,Tuner, CD/DVD, Aux| less than 0.4%
less than 0.4%
less than 0.2%
Signal to Noise Ratio
Mic
Phono
Tape,Tuner, CD/DVD, Aux| more than 50dB
more than 70dB
more than 80dB
Frequency Response| 5Hz • 30kHz +0 ·3dB
Tone Control
Bass
Midrange
Treble| ± 12dB@ 100Hz
± 6dB@ 1kHz
± 12dB@ 10kHz
Loudness Control
Power **Requ irements
Dimensions**| +4/0/+2dB @ 100/1k/1 0kHz
AC 120V 60Hz / 220V 50Hz
18.9″ X 2.36″ X 8.25″
Warranty Information
All OSD AUDIO electronics have (2) year Limited Warranty against defects in
materials and workmanship. Proof of purchase must accompany all claims. During
the warranty period OSD AUDIO will replace any defective part and correct any
defect in workmanship without charge for either parts or labor OSD AUDIO may
replace returned electronics with a product of equal value and performance. In
such cases, some modifications to the mounting may be necessary and are not
OSD AUDIO’s responsibility. For this warranty to apply, the unit must be
installed and used according to its written instructions. If necessary,
repairs must be performed by OSD AUDIO. The unit must be returned to OSD AUDIO
at the owner’s expense and with prior written permission. Accidental damage
and shipping damage are not considered defects, nor is damaged resulting from
abuse or from servicing performed by an agency or person not specifically
authorized in writing by OSD Audio OSD AUDIO sells products only through
authorized dealers and distributors to ensure that customers obtain proper
support and service. Any OSD AUDIO product purchased from an unauthorized
dealer or other source, including retailers, mail order dealers and online
sellers will not be honored or serviced under existing OSD AUDIO warranty
policy. Any sale of product by an unauthorized source or other manner not
authorized by OSD AUDIO shall void the warranty on the applicable product.
Damage to or destruction of components due to application of excessive power
voids the warranty on those parts. In these cases, repairs will be made on the
basis of the retail value of the parts and labor. To return for repairs, you
must email customer service at RMA@OSDAUDIO.com for a Returned Merchandise
Authorization (RMA) number then the unit must be shipped to OSD AUDIO at the
owner’s expense, along with a note explaining the nature of service required.
Be sure to pack the product(s) in a corrugated container with at least 3
inches of resilient material to protect the unit from damage in transit.
This Warranty Does Not Cover: Damage caused by abuse, accident, misuse,
negligence, or improper operation (installation) • Any products that have been
altered or modified • Any product whose identifying number of decal, serial #,
etc. has been altered, defaced or removed • Normal wear and maintenance.
OSD Audio | Brea, CA | osdaudio.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>