OSD AUDIO SPW-8 150W 8-Zone Speaker Instruction Manual
- June 4, 2024
- OSD AUDIO
Table of Contents
OSD AUDIO SPW-8 150W 8-Zone Speaker
SPW-8 Distribution Unit
The OSD AUDIO SPW-8 is a one IN/ eight OUT speaker wire distribution unit. The
SPW-8 provides a simple solution in complex speaker installations with an easy
way to connect from two to eight pairs of speakers to a single
amplifier/receiver. All outputs are labeled easing both connection and
troubleshooting of a system.
Note:
The SPW-8 does not provide any internal impedance protection thus requiring
the volume controls to provide impedance protection to protect the amplifier;
the SVC-100, SVC-300, VMS-100. VMS-300 and VKR-120 all feature selectable
impedance protection.
Warning:
Always turn off the amplifier or receiver when connecting speakers or any
other components to the system. Failure to do so may cause damage to the
speakers, electronics, or both.
Connections
The SPW-8 features a total of nine connectors; one input and eight output connectors ( Installation 1). To wire the connector, strip 1 /4″ (7mm) insulation off of the end of each wire. Connect the wires to the removable connector plugs using a small flathead screwdriver ( Installation 2). The plugs are labeled and color-coded to simplify installation, the red connector is for the speaker wires coming from the amplifier and the black connectors are for the wires going out to the speakers. Plug the connector plugs into the SPW-8 ( Installation 3).
- OSD AUDIO
- 1405 Pioneer St
- Brea
- CA
- 92821
- Tel 562-697-2600
- Fax 562-697-2668
- Tech Support 562-697-2600
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>