anslut 019924 LED Flood Light Instruction Manual

019924 LED Flood Light
Instruction Manual

LED FLOODLIGHT 019924

019924 LED Flood Light

Jula AB reserves the right to make changes to the product. Jula AB claims copyright on this documentation. It is not allowed to modify or alter this documentation in any way and the manual shall be printed and used as it is in relation to the product. For the latest version of operating instructions, refer to the Jula website. 

SAFETY INSTRUCTIONS

• The power cord cannot be replaced.
  The whole product must be replaced if the cord is damaged.

• The product must be connected to an earthed power point.

• Regularly check all electrical connections and power cords for damage. Any faults must be rectified before using the product. Always have the wiring and connections  checked by an authorised electrician.

• Check that the mains voltage is the same as the power supply voltage stated on the type identification plate.

• Do not use the product if the glass cover is cracked or damaged. The product must be discarded if the glass cover is cracked or damaged.

• The light source is not replaceable.
  The entire product must be replaced if it stops working.

SYMBOLS

| Read the instructions.
---|---
| Approved in accordance with the relevant directives.
| Recycle discarded product in accordance with local regulations.
| Warning: Risk of electric shock.
| Non-replaceable actuator.
| Non-replaceable light source.

TECHNICAL DATA

ASSEMBLY

WARNING!
Check that the mains supply is disconnected before starting installation.
WALL BRACKET POSITIONING

• The ideal height for the bracket is approx. 2.5 m.
• To prevent incorrect activation, place the product away from radiators, climate control units and other sources of heat.
• Place the product so that the PIR sensor is not exposed to direct light as this may cause the product to malfunction.
• Make sure the product is not exposed to strong electromagnetic fields.

ASSEMBLY

1. Switch off the power supply.
   FIG. 1

2. Remove the mounting plate from the product using a Phillips screwdriver.
   FIG. 2

3. Depress the lock button on the mounting plate and pull the plate out of the product’s casing using the ribbon.
   FIG. 3

4. Drill holes through the punched fastening holes, mark their position on the wall and drill the holes in the wall. Insert wall plugs into the holes.
   FIG. 4

5. Pierce a hole through the rubber cable grommet using a screwdriver, for example, and insert the cable from the rear.
   FIG. 5

6. Screw the mounting plate to the wall using a Phillips screwdriver.
   FIG. 6

7. Remove the 2 screws and the strain reliever.
   FIG. 7

8. Connect the cable wires correctly to the terminals on the mounting plate as indicated.
   FIG. 8

9. Lock the cable with the strain reliever and the 2 screws.
   FIG. 9

10. Place the product on the mounting plate ensuring it is straight. Depress the lock button and press the product against the wall until the lock button clicks into place in  the casing. Insert the screws from below, through the casing into the mounting plate, and tighten with a Phillips screwdriver.
    FIG. 10

11. Switch on the power supply.
    FIG. 11

USE
The product has the following 4 modes. To see which mode has been selected, press on the mode button.

1. Night mode with light and rotation (flashes once)
2. Day and night mode with light and rotation (flashes twice)
3. Night mode with light without rotation (flashes 3 times)
4. Day and night mode with light without rotation (flashes 4 times)
   When the light is powered on, it rotates as a self test and defaults to mode

5. When selecting a new mode, the change will take effect after the rotation has completed.

MAINTENANCE

RECYCLING
Light source
Recycle end-of-life product in accordance with local regulations. The light source should be removed from the lamp and recycled separately.

FIG. 12
FIG. 13
FIG. 14
Actuator
FIG. 15
FIG. 16
FIG. 17

2022-11-08
WWW.JULA.COM
© JULA AB
JULA AB
BOX 363, 532 24 SKARA, SWEDEN

Documents / Resources

| anslut 019924 LED Flood Light [pdf] Instruction Manual
019924 LED Flood Light, LED Flood Light, 019924 Flood Light, Flood Light, Light, 019924
---|---

References

• Jula – products for home and garden

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>