AUDIBAX Ground SUB10T Subwoofer User Manual
- June 9, 2024
- AUDIBAX
Table of Contents
Ground SUB10T Subwoofer
User Manual
Ground SUB10T Subwoofer
Please read the manual before using the product
SAFETY INSTRUCTIONS
- Please read the instructions carefully before installation and use. Keep the manual safe for future reference.
- When installing Ground SUB10T speaker outside do not submerge or place them in direct contact with water (e.g., ponds, waterfalls, fountains).
- Damage to the woofer may occur if the speaker is dropped or hit – resulting in no sound or distorted sound.
- Use only approved and certified wiring in your installation, do not stretch or place the wire in contact with sharp objects.
- Never overdrive your speakers to the point of distortion and always reduce volume prior to switching input sources (e.g., FM to CD).
- Prior to removing cables ensure all power to your amplifier and other components is turned OFF.
- Turn off the power to the speaker when unused for long periods of time.
PACKING LIST
INSTALLATION
Deck mount
- Determine where you want to locate the subwoofer.
- Measure the center-to-center distance between the key-hole slots and install two mounting screws into the deck, leaving 1/4″ of the screws exposed above the surface.
- Place the subwoofer onto the pan head screws and rotate the Ground SUB10T clockwise so that the keyhole slots lock down onto the pan head screws.
Garden Placement
You may locate Ground SUB10T anywhere you can run speaker wire. If you place
your subwoofer in a garden bed, on grass, mulch or upon soft ground, we
recommend you place it on a paver or other hard surface and remove all gravel
or debris prior to installation. This will prevent plants, weeds, mulch or
dirt from building-up underneath the subwoofer, which must remain clear for
optimum performance and to prevent damage to driver.
Note: For anti-theft security and permanent placement the Ground SUB10T
has a built-in eyebolt that enables you to anchor it to its location.
SPECIFICATIONS
| MODEL | Ground SUBlOT |
|---|---|
| Woofer | 10″Polypropylene Cone |
| RMS Power | 150W |
| Frequency Response(±3dB) | 50Hz-300Hz |
| Nominal Impedance | 4 |
| Sensitivity | 86 |
| IP Level | IP 65 |
| Product Dimension(mm) | 1 310x420x420 (12.2″x16.5″x16.5″) |
CARE AND MAINTENANCE
Make sure to turn all equipment off before cleaning. The cabinet only needs occasional dusting. Please do not touch the drive units. Do not clean the speaker with chemical solvents as this may damage the paint surface. Clean with a dry cloth.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>