juno JFX Series Linear Lighting System MLV Driver Instruction Manual

: June 9, 2024
: Juno

Table of Contents

juno JFX Series Linear Lighting System MLV Driver
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
WARRANTY
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

juno JFX Series Linear Lighting System MLV Driver

WARNING: ACCUDRIVETM Series Class 2, 24VDC Magnetic Low Voltage Drivers should only be used with JFXTM Series LED strips. Use of non-JFX™ LED strips may damage driver and void warranty. See Driver Spec sheet for more detailed information. Failure to follow instructions will void product warranty.

IMPORTANT SAFETY INSTRUCTIONS

Read all these instructions before starting installation.
Keep these instructions in a safe place for future reference.
Only qualified electricians in accordance with local codes should install these fixtures.
De-energize electrical circuit at circuit breaker prior to installation process. Always ensure power is off before making any changes to installation.
Do not disassemble or modify these products beyond instructions or warranty will be voided.
Do not install driver horizontally. It must be mounted on a wall or other vertical surfaces.
Do not install in confined or unventilated areas that may entrap heat.
Do not submerge or install within 5ft from a body of water.
Ensure wire gauge used from driver to LED strip is sufficient to maintain a voltage drop under 3% (See Spec Sheet for details).
Do not exceed stated maximum LED strip run (See Spec Sheet for details).
Driver should be loaded to 80% maximum. (i.e. 76W for 96W model)
Minimum Load: 20% for full range dimming & On/Off switching.

SAVE THESE INSTRUCTIONS

Step 1. Select a mounting location for the driver, taking care to observe the above listed safety/operating instructions. Driver must be mounted vertically for proper heat dissipation. The mounting tabs should be at the top and the wiring compartment at the bottom when properly mounted.
Step 2. Remove wiring compartment cover. Remove the appropriate knockouts to accommodate the type of electrical supply being used in accordance with the national and/or local electrical codes.
Step 3. Strip supply wire 3/8” and insert each supply wire into appropriate connector. Connect black driver wire to hot, white wire to neutral, & green wire to ground (Figure 1).
Step 4. Connect LED strips to driver by inserting driver output wire into appropriate connector. Connect driver red wire (V+) to corresponding red wire (V+) coming from LED strip & blue wire (V-) to corresponding black wire (V-) coming from LED strip (Figure 1).
Step 5. Place all wiring & connectors back in wiring compartment & replace cover.
Notes (Auto Reset Breaker): Both primary & secondary circuits are protected with an automatic reset breaker. A tripped circuit is indicated by the LED strips powering off. Reset may take between 50 seconds to 5 minutes depending on load size.
FIXTURE DIMMING AND WIRING
120VAC (120) DRIVER (Non RGBW)
Dimmable with the use of most magnetic low voltage dimmers. See Spec sheet for a list of compatible dimmer models.
Note: Some low voltage dimmers require a neutral wire connection at the dimmer.