Alphacool RX 7900 XTX Introduces Water Blocks User Manual
- June 9, 2024
- ALPHACOOL
Table of Contents
Alphacool RX 7900 XTX Introduces Water Blocks
INTRODUCTIONS
Prepare graphics card
Put the hardware on an antistatic mat. Begin dismantling the original cooler. Depending on the structure of the cooler, remove the screws at the back of the card and carefully unhook the fan connector first. If the original cooler uses thermal glue, extreme care should be taken as you can easily damage parts. Pick up all the items carefully. Next, clean the hardware of thermal paste or pad residues with a solvent (e.g. isopropanol alcohol).
Check compatibility
Before starting the cooler assembly, compare your card with the pictures in
our configurator. To do so, visit https://www.hwconfig.com and search for
your graphics card or cooler model. For a definitiv identification, you can
also compare the PCB number.
The cooler was designed for a special PCB layout.
Occasionally, graphics card manufacturers may revise the design of their card
slightly, causing the cooler not to fit on later models.
During assembly, please make sure taller parts have enough space around them
and that the cooler does not damage your graphics card.
Alphacool International GmbH is not liable for assembly errors occurring due
to negligence, such as selecting an incompatible cooler.
Place thermal pads on cooling block
Apply Thermal Grease
Install PCB
Install PCB
Place thermal pads on PCB backside
Mount backplate and PCI Bracket
Connect ARGB lighting
Screw in screw plugs with the tool
Need help?
Alphacool International GmbH Marienberger Str. 1
D-38122 Braunschweig Germany
Support: +49 (0) 531 28874 – 0
Fax: +49 (0) 531 28874 – 22
E-mail: info@alphacool.com
https://www.alphacool.com