ACCORD LIGHTING 4025 G-9 Wall Lamp Accord Clean Instruction Manual
- June 8, 2024
- ACCORD LIGHTING
Table of Contents
ACCORD LIGHTING 4025 G-9 Wall Lamp Accord Clean
WARNING!
Be sure electrical power is OFF before and during installation or maintenance.
The luminaire must be installed by a qualified electrician, in accordance with
all applicable local codes.
Ensure that the rated luminaire voltage requirements are compatible with the available mains supply in which it will be installed. All LEDS are included in your lamp. Never touch the LED surface with your bare hands as this may reduce the life of your LED. Do not alter, relocate or remove any electrical component.
Specification
- Line: Clean
- Family: Pendant
- Description: Clean Accord Wall Lamp 4025
- Material: Natural Wood Veneer MDF
INSTALLING THE FIXTURE ON WALL
Turn OFF the power before starting the installation.
MAKING ELECTRICAL CONNECTIONS
-
Pass the power supply cable through the off-center hole on the lampholder base and crossbar.
-
Connect the electrical supply wires to the junction box in accordance with all applicable local codes, as shown in the diagram.
MOUNTING ON THE FIXTURE -
Attach the crossbar to the wall using the supplied screws.
-
After electrical connections are made, place excess wire inside the junction box.
-
Fix the lampholder base to the wall using the supplied screw(s).
-
Once the base is fixed, install the G-9 base bulb(s) (not included) into the G-9 lampholder(s) within the fixture.
-
Bring the luminaire to the wall and leave it on top of the installed base until everything rests straight.
Turn ON the electrical power.
Your luminaire is now ready for use.
ATTENTION!
FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY CAUSE ACCIDENTS AND LOSS OF
PRODUCT WARRANTY. Its recommended to read these instructions completely and
carefully before proceeding.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
ACCORD Lighting guarantees coverage against manufacturing defects including electrical components and finishes, for a period of three years, under normal use, from the date of purchase. For warranty service, please contact your local dealer for further instructions. Proof of the date of purchase will be required for validation of warranty service.
The responsibility of the manufacturer regarding the product warranty is related to the correct observation of the instructions contained in this manual. The manufacturer is not responsible for any damage to the product caused by accidents, alterations of any kind, improper usage, or improper installation. See the website for additional warranty details.
ACCORD Lighting reserves the right to change the dimensions and specifications contained in this manual without prior notice, in accordance with its policy of continuous product improvement. Please, contact the manufacturer if additional information is necessary. The illustrations in this manual are for guidance only and may vary in scale, dimensions, and model details.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>