RUST-OLEUM ROC-94 Elastomeric Roof Patch User Manual

June 8, 2024
Rust-Oleum

TRUSTED QUALITY SINCE 1921
TECHNICAL DATA

ROC-94
ELASTOMERIC ROOF PATCH

DESCRIPTION AND USES

Rust-Oleum ® Elastomeric Roof Patch is a white, acrylic elastomeric roof sealant intended for application to metal, asphalt, modified bitumen and most single-ply roofs. The
highly flexible, rubber-like elasticity accommodates wide swings in temperature and significant building movement. Rust-Oleum Elastomeric Roof Patch is UV stable and may
be used to repair roofs and seal metal roof fasteners. For exterior use only.

PRODUCT FEATURES

  • Excellent adhesion & flexibility
  • Patches seams & splits and seals roof fasteners
  • Easy water clean up
  • 10 Year warranty
  • Use for residential shingled, modified bitumen, built-up, metal, and aged single-ply roofing systems

PRODUCT

SKU DESCRIPTION
301898 1 Gallon

PRODUCT APPLICATION

SURFACE PREPARATION
All surfaces must be clean, dry, sound and free from dirt, grease, oil, mold, algae, loose granules, loose gravel, loose paint, rust, excess chalk and other foreign matter which
could prevent proper adhesion. Rusted areas must be primed with Rust-Oleum Universal Roof Primer or a similar product. Surface temperatures should be under 100ºF (38ºC) to avoid premature curing. If the roof surface is hot, apply a light water spray to reduce the surface temperature.
WARNING! If you scrape, sand or remove old paint, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-Approved respirator to control lead exposure. Clean up carefully with a HEPA vacuum and a wet mop. Before you start, find out how to protect yourself and your family by contacting the National Lead Information Hotline at 1-800424-LEAD or log on to www.epa.gov/lead.
PRODUCT APPLICATION (cont.)
APPLICATION
Apply only when air, material, and surface temperatures are between 40-100ºF (4-38ºC) and the relative humidity is below 85%.
Apply with a brush or trowel (⅛-¼”) thick. Extend the material two inches on either side when sealing fasteners. For added strength, reinforce seams and repairs with Rust-Oleum Universal Patching Fabric between two applications of Rust-Oleum Elastomeric Roof Patch.
COVERAGE
Approximately 12 square feet per gallon when applied at ⅛ inch (125 mils) wet film thickness. Actual coverage may vary depending upon application method.
DRY & RECOAT TIMES 
Dry and recoat times are based on 70ºF and 50% relative humidity. Allow to dry at least 4 to 8 hours for a thorough dry before recoating with an acrylic based roof coating. Product will reach full cure in 24 hours. Environmental or site specific conditions may lead to a variation in dry time.
CLEAN-UP
Wash tools and equipment with soap and water. Wipe up spills before they dry. Properly dispose of all soiled rags and containers.
LIMITATIONS
Do not store above 90ºF (32ºC). Apply only at temperatures above 40ºF (4ºC) and when the surface temperature is under 100ºF (38ºC). Do not apply if rain is expected within 48 hours of application or if the humidity is greater than 90%.
PROTECT FROM FREEZING

PHYSICAL PROPERTIES

| ELASTOMERIC ROOF PATCH
---|---
Resin Type| Elastomeric Acrylic
Pigment Type| Titanium Dioxide, Mineral
Solvents| Water
Weight| Per Gallon| 11.5 lbs.
Per Liter| 1.38 kg
Solids| By Weight| 69%
By Volume| 55%
VOC| <25 g/I
Practical Coverage| Approximately 12 square feet per gallon when applied at ‘A inch (125 mils) wet film thickness
Dry Times at 70-80°F (21-27°C) and 50% Relative Humidity| Through Dry| 4-8 hours
Full Cure| 24 hours depending on temperatures
Shelf Life| 3 years
Safety Information| For additional information, see SDS

The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All technical information is subject to change without notice.
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061

Phone: 844∙888∙0485www.rustoleum.com
Form: GDH-1296
Rev.: 092121

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Rust-Oleum User Manuals

Related Manuals