beper P102GEL001 Automatic Ice Cream Maker Instruction Manual
- June 8, 2024
- beper
Table of Contents
beper P102GEL001 Automatic Ice Cream Maker
Precautions
Read the following instructions carefully, since they give you useful safety information about installation, use and maintenance and help you avoid mishaps and possible accidents.
Remove the packing and make sure that the appliance is intact, with special attention to the supply cable.
The elements of the packing (plastic bags, polystyrene, etc) do not have to be accessible to the children, in order to preserve them from danger sources. It is recommended not to throw these packing material in the domestic waste, but to deliver them to the appropriate station of collection or destruction refusals, asking eventually information to the manager of the Sanitation Department of your own municipality.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
Before connecting the appliance make sure that the mains voltage corresponds to the data specified on the label. The appliance can be damaged if the voltage is not correct. If the plug does not suit the socket, let it be replaced with another suitable plug by qualified personnel only, which shall also ensure that the section of the socket cables is suitable for your appliance power absorption.
Generally, the use adaptors multiple plugs and/or extensions is not recommended; should they be necessary, please use only simple or multiple adaptors and extensions in compliance with the safety rules in force, making sure that the capacity absorption limit marked on the simple adaptors and the extensions and the maximum power limit marked on the multiple adaptor are not exceeded.
Do not use the appliance if the cable or the plug shows any damages. Do not use the appliance after a possible irregular working. In this case, switch it off and do not break it open. Refer to an authorized Beper after-sale service for repair and require original spare parts only. Failing to follow these instructions may impair the safety of your appliance.
This appliance is to be destined to its special purpose only. Any other use is to be considered as improper and thus dangerous. The manufacturer cannot be responsible for any damages deriving from improper, wrong or incautious use.
This appliance is for household use only.
To protect against electric shock, do not immerse cord, plug or any parts of
the appliance into water or other fluids.
Do not use the appliance near explosives, highly flammable materials, gases or
burning flames.
Do not allow children, disabled people or every people without experience or technical ability to use the appliance if they are not properly watched over. Close supervision is necessary when any appliance used by or near children.
Description Fig. A
- Motor unit
- Power button (on/off)
- Axis of the mixing paddle
- Transparent lid
- Mixing paddle
- Cooling bowl
Before using the appliance for the first time
Clean the cooling bowl, lid, the mixing paddle and its axis using a sponge or cloth with warm water and mild detergent. Do not use the dishwasher. Rinse and fully dry the whole appliance.
Freezing the cooling bowl
The most important step to make ice cream is to ensure that the cooling bowl
is properly frozen.
The liquid between the walls of the cooling bowl must be completely frozen
before using the ice cream maker and adding your mix of ingredients.
Place the cooling bowl in your freezer. Check that the freezer temperature is
around -18 ° C.
The time required to properly freeze the cooling bowl (minimum 8 hours) will
depend on the temperature of and how full your freezer is. For best results,
place the cooling bowl at the bottom of your freezer where the temperature is
the coldest. Shake the bowl to check the level of freezing: you should no
longer hear the sound of liquid inside.
Assembly of the appliance
Rotate the motor unit and insert the axis of the mixing paddle. Insert the
motor unit in the transparent cover. Assembly the motor unit with the
transparent cover; match the slot of the pin with the edge of the lid and
press the lid and the motor unit one over the other to make them fit snugly.
Mount the mixing paddle.
Take the freezing bowl out of the freezer and make sure it is properly frozen.
Place the motor unit over the bowl and secure it in place by turning
clockwise.
Press the power button to start the mixing paddle rotation. Immediately add
the mixture of ingredients through the opening in the upper part of the
transparent lid. Let the unit run for about 20-40 minutes. Do not leave the
appliance on for more than 1 hour.
Tip: The consistency of homemade ice cream is usually softer than that of industrial ice cream. If the ice cream is too liquid: pour it into another container using a rubber spatula or a wooden spoon and put the container in the freezer to harden the ice cream; reduce the quantity of eggs in the mixture; keep the mixture in the fridge for 30 minutes.
Maintenance
The cooling bowl, mixing paddle and the lid can be washed in warm water with a
mild detergent. Rinse thoroughly. Do not put any parts in the dishwasher.
The motor unit can be cleaned using a warm, damp cloth. And never immerse the
motor unit in water. Make sure all parts are completely dry before storing.
Never place the cooling bowl in the freezer if it is still damp. Never store
the motor unit, mixing paddle or axis in the freezer.
Technical Data
Power: 12W
Voltage: 220- 240V ~ 50Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Old appliances must be collected separately in order to optimize the recovery and recycling of the materials they contain, and reduce the impact on human health and the environment. The crossed out “wheeled bin” symbol on the product reminds you of your obligation, that when you dispose of the appliance, it must be separately collected.
GUARANTEE CERTIFICATE
This appliance has been checked in the factory. From the date of original purchase a 24 month guarantee applies to material and production defects. The purchase receipt and the guarantee certificate must be submitted together in case of claim to guarantee.
The guarantee is valid only with a guaranty certificate and proof of purchase (fiscal receipt) indicating the date of purchase and the model of the appliance
For any technical assistance, please contact directly the seller or our head office in order to preserve the appliance’s efficiency and NOT TO void the guarantee. Any intervention on this appliance by non authorized persons will automatically void the guarantee.
GUARANTEE CONDITIONS
If the appliance shows defects as a result of faulty material and/or production during the period of guarantee, we guarantee repair free of charge on condition that:
- The appliance has been used properly and for the purpose for which it has been intended.
- The appliance has not been tampered with, otherwise it is not maintainable.
- The purchase receipt shall be presented.
- The appliance showing a fair wear and tear shall not be covered by this guarantee.
Therefore, any part that could be accidentally broken or having visible signs
of use in consumable products (such as lamps, batteries, heating elements…)
the aesthetic parts are excluded from the guarantee, and any defect whatsoever
resulting from non-respect of the rules for use, negligence in usage and/or
maintenance of the appliance, carelessness, wrong or improper installation,
damage during transport and any other damage not attributable the supplier.
For every defect that could not be repaired within the guarantee period, the
appliance will be replaced free of charge. In any case, if the part to be
replaced for defect, breakage or malfunction is an accessory and/or a
detachable part of the product, Beper reserves the right to replace only the
very part in question and not the entire product.
YOU MIGHT ALSO LIKE
Drink Mixer
Cod.: BP.690
Ideal for preparing cocktails, milkshakes, protein shakes, cold coffee and for
whipping egg whites
2 speeds to obtain the desired consistency
500ml graduated stainless steel beaker
Non-slip feet for maximum stability
Dishwasher safe beaker
Contact your distributor in your country or after sales department Beper.
E-mail [email protected] which will forward your enquiries to your distributor
CUSTOMER CARE BEPER
BEPER SRL
Via Salieri, 30 – 37050 – Vallese di Oppeano – Verona
Tel. 045/7134674 – Fax 045/6984019
beper.com 
