Milesight UR32S Industrial 4G Router User Guide

: June 8, 2024
: Milesight

Table of Contents

Packing List
Hardware intruduction
Fitting Installation
Router Installation
Remote Managemant
Web GUI Access
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

UR32S Industrial 4G Router
User Guide

Packing List

Please check the package contents to verify that you have received the items below.

If any of the above items is missing or damaged, please contact your sales representative.

Hardware intruduction

How to reset the device to factory default?
Find the reset button under SIM slot; press and hold the reset button for more than 5 seconds until SYSTEM LED is rapidly blinking.

Fitting Installation

Step 1: Insert the SIM card in to the device according to the arrow icon on the device.

Step 2: Rotate antennas into the antenna connectors. Antennas should be installed vertically and the device should be placed always on asite with a good signal.

Router Installation

Before you start, make sure that your SIM card has been inserted, your antennas have been attached and all cables have been installed.
Note: Do not connect device t o power supply or other devices when installing.
Drill four holes on the wall by using yourdrill and insert four wall plugs into the holes respectively, and then use 4 pcs of M3 x 6 flat head Phillips screws to fix the router on the wall.

Remote Managemant

Step 1: Connect the WAN port of the router to the same LAN as the devices (including cameras and NVRs).
Step 2: Enable Wireless Network Connection on your mobile phone and search for access point “Router_**” (last 6 bits of MAC address) to connect it.
Step 3: Open the M-Sight Pro APP, search for and bind the router as shown below.
Username: admin
Password: password

Step 4: Select the devices you want to share with installers or technicians from the list of detected devices.

Step 5: The installers or technicians can remotely configure shared devices on Milesight CMS by adding the routers to Milesight CMS.

Note: You can check the SN code on the sticker o r web GUI of the router.

Web GUI Access

UR32S provides web-based configuration interface for management. If this is the first time you configure the router, please use the default settings below:
Username: admin
Password: password
Browser: Chrome (recommended)
Note: You can check the IP address of the router on M-Sight Pro APP.

Enable Wireless Network Connection on your computer and search for access point “Router_**”(last 6 bits of MAC address) to connect it. After it is connected, type the LAN I P of the router to your Internet browser to log i n the web GUI of routers.

All Software & files can be downloaded from
http://www.milesight.com/support/download.asp

Troubleshooting

Milesight Technology Co., Ltd.
www.milesight.com
Better Inside, More in Sight