SCHLAGE BE467F Control Smart Deadbolt Instruction Manual
- June 4, 2024
- Schlage
Table of Contents
SCHLAGE BE467F Control Smart Deadbolt
Tools Needed
Measure door thickness.
- If the door is thinner than 1C\,” or thicker than 1C\v”, then the lock will not fit properly on the door
Measure the backset.
- If existing backset is not 2C\,” or 2C\v”, then the lock will not fit properly on the door.
Measure the hole sizes.
- If hole sizes are larger than those shown, then the lock will not fit properly on the door. If hole sizes are smaller than those shown, see steps 3b and 3c.
- 3b If necessary, enlarge hole in door face.
- 3c If necessary, enlarge hole in door edge.
Check the door jamb.
- Place new strike and reinforcement plate against the door jamb. If these do not fit properly, see steps 4b and 4c.
- 4b If correction is necessary, trace the faceplate and mark holes.
- If necessary, use chisel, hammer and drill to correct door jamb preparation
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>