FE410F Schlage Control Smart Deadbolt Instruction Manual
- June 4, 2024
- Schlage
Table of Contents
FE410F Schlage Control Smart Deadbolt
Tools Needed
INSTRUCTION
Door Preparation Instructions for Door with Existing Holes
- Measure door thickness.
- If the door is thinner than 1C\,” or thicker than 1C\v”, then the lock will not fit properly on the door.
- Measure the backset.
- If existing backset is not 2C\,” or 2C\v”, then the lock will not fit properly on the door.
- Measure the distance between the two holes.
- The two holes must be either 4” or 5Z\x” apart. If they are not, the lock will not fit.
- Measure the hole sizes.
- If hole sizes are larger than those shown, then the lock will not fit properly on the door. If hole sizes are smaller than those shown, see steps 4b and 4c.
- If necessary, enlarge holes in door face.
- If necessary, enlarge holes in door edge.
- Check the door jamb.
- Place new latch strike, and bolt strike and reinforcement plate against the door jamb. If these do not fit properly, see steps 5b and 5c .
- If correction is necessary, trace the faceplates and mark holes.
- If necessary, use chisel, hammer and drill to correct door jamb preparation.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>