EENOUR S32 Portable Freezer Truck Fridge Dual Zone User Manual

EENOUR S32 Portable Freezer Truck Fridge Dual Zone

BEFORE FIRST USE
To prevent any internal damage, it is very important to keep this portable refrigerator upright through­out the journey. Please leave this unit standing upright on a level surface for about 12 hours before powering it on.

GENERAL INFO
Within this manual you can find information regarding the proper use and maintenance of your­brand-new portable refrigerator. The safety precautions enclosed herein reduce the risk of fire, electric shock and injury when correctly adhered to. Keep the manual in a safe place for future reference.

CONTACT US
We are ready to help you with any questions, concerns, or issues about your new product. You can email us (support@eenour.com)) or enter our website (eenour.com) for more information and help.

SAFETY INSTRUCTION

Please read the following instructions provided below to avoid personal injury and damage to the prod­uct.

General Safety

• This portable refrigerator is not intended for use by persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to avoid injury or damage to the refrigerator.
• Do not place the unit under direct sunlight or near heat sources.
• Please avoid leaving food or cleaning agents in the unit.
• Do not use abrasive cleaners on the product.
• Try not tilt the refrigerator, though it works properly under the maximum inclination angle 30 degrees. (Note: If the inclination angle exceeds 15 degrees, the noise will increase when the refrig­erator is working, but no influence to the refrigeration function)
• Never use hard or sharp implements to remove ice from the cooling compartment.
• Do not fill the unit with water.

Electrical Safety

• Make sure your hands are dry before handling the plug or switching on the appliance.
• Never touch the damaged power cable directly with your hands, especially when it is connected to AC mains supply.
• Make sure your local outlet voltage matches the appliance rating label of the unit.
• Keep the unit at a dry location and away from various water sources.
• Do not use electrical devices inside the refrigerator.
• Do not pull the cord to disconnect the outlet, or to carry the unit.
• Do not disassemble any part of the unit once it is powered on.
• Do not pinch or kink the power cord.
• Make sure to not exceed the given power outlet ratings.
• Make sure the unit is turned off and unplugged when clearing it.

DIAGRAM & PACKAGE CONTENTS

Your portable refrigerator comes with the items listed below. Please check to see that all of the follow­ing items are included in the package.

MAINTENANCE AND CARE

Proper handling and installation

1. Once the portable refrigerator has been removed from the packaging, place it on a level & dry surface and away from direct heat sources. Wait about 12 hours before turning on the refrigerator, as it may have been tilted in the warehouse or during delivery.
2. lt is recommended to clean the inside of the refrigerator before use.
3. Connect the AC power cord with the AC adapter and insert the AC power cord into a (1 00V-240V)AC outlet, or insert a 12V/24V DC power supply with the DC power cord.
4. Avoid moving or tilting the refrigerator when it is turned on.
5. lf moving the product, keep it level and try to avoid tilting it (to protect the compressor).

Proper Placement of your unit

• Do not submerse the unit in water.
• Place the refrigerator on level ground (max inclination angle:30°).
• In order to ensure proper ventilation of the refrigerator during working, please keep a distance of 4 inches between each side of the product and other objects.
• Avoid placing the unit in direct sunlight or high-temperature areas to ensure efficient cooling function.
• Do not place the unit in a “built-in” area.
• The portable refrigerator is not weather proof. Do not put it under rain or other harsh weather condi­tions.
• Close the lid immediately after use to ensure a proper cooling performance.

Maintaining your unit

• If you are not planning on using your portable refrigerator, disconnect the freezer from the power supply and place it on a flat & dry surface.
• Store the unit away from children.
• When cleaning the unit, make sure the power is off and the cables are disconnected.
• The unit can be internally and externally cleaned with diluted(with water) cleaning agents such as detergent, soap, baking soda etc.
• Do not use abrasive cleaning agents.
• If the inside is covered with frost(a bad influence on the cooling performance), please turn off the refrigerator, allow the ice to melt, and wipe the water out.

DISPOSAL
When it comes to the end of its working life, your refrigerator should be disposed of responsibly to ensure that it does not contaminate the environment. It would be advisable to contact your local council for advice on the disposal of this unit.

CONTROL PANEL & GENERAL OPERATION

1. POWER” Button:
   Connect the refrigerator to the power supply and touch the POWER button once to turn it on. It will show you the current temperature of the freezer room. Press the POWER button again for about 2 seconds to turn it off.

2. “UP” Button:
   For increasing the temperature and mode changing.

3. “DOWN” Button:
   For decreasing the temperature and mode changing.
   When the car refrigerator is on, you can set the temperature range from -4° F to 50° F. Touch the “UP” or “DOWN” button once to enter the temperature setting page. Then, short press “UP” or “DOWN” button or long press one them for about 2 seconds to adjust the desired temperature in the freezer room. Then, the displayed screen will flash five times and back to the current temperature page.

4. “SET” Button:
   Touch the “SET” button once to see the current working mode: “ECO”(energy- saving mode)/ “HH”(fast cooling mode). You can use the “UP” and “DOWN” buttons to choose the mode needed.
   Touch the “SET” button twice to enter the voltage protection settings: “Lo”(low)/ “nE”(medium)/ “Hl”(high). You can use the “UP” and “DOWN” buttons to choose one mode out of three. The refrigera­tor will turn off automatically when the voltage reaches the corresponding range.
   After you choose the mode, the displayed screen will flash five times and back to the current tempera­ture page.
   Nate: The supplying battery remains more capacity with higher voltage protection mode. We do not recommend the “Lo” mode in case of draining your vehicle’s battery. Here is a table to show the volt­age parameters in different settings.

Battery Protection Mode| Start Voltage Parameters(12V DC Input)| Start Voltage Parameters(24V DC Input)
---|---|---
Lo| 10.3-11.2| 21.5-22.7
nE| 10.8-11.8| 22.3-23.7
HI| 11.3-12.6| 24.3-25.7

Values are for reference only and may be subject to changes depending on conditions and power supply
Indicator Light CD :

• When the refrigerator works in “HH” mode, the light is red.
• When the refrigerator is in “ECO” mode, the light is green.
• When the refrigerator is off, the light is off.

Indicator Light

• When the refrigerator works well, the light is green.
• When the temperature of the freezer room meets your requirement, the compressor will stop working and the light will turn red.
• If there is a failure during working, the screen may show the related fault code (F1-F5,explained in the section below), and the light will turn red.

TROUBLESHOOTING

| |
---|---|---

Does not work

| Voltage input is too low| Use another power supply

Loose connection

| Check all of the connections from the power source

to the refrigerator

The fuse is blown or loose

| Connect the fuse correctly or use another one

Bad cooling performance

| Food or drinks in the fridge is too much or overheated| Move some of the food or drinks out
The refrigerator lid is open for a long time or is not closed well| Close the refrigerator lid and check the lid seal

Product’s lid seal is damaged

| Replace the lid seal with a new one

Poor ventilation

| Check if the vents of the refrigerator is blocked and keep a distance of more than 4 inches(10 cm) between the vents and other objects

Ambient temperature is too high

| Place the refrigerator in a cooler area and avoid direct sunlight.
Temperature setting is too high| Set the temperature lower
Abnormal noise during working|

The refrigerator is tilted too much

| Place the refrigerator horizontally or move it to a flat place

Water flow noise

| A normal phenomenon, which is caused by the flow of refrigerant in the pipeline|

Error Code Information

| |
---|---|---

F1

| ****

Low input voltage

| DC lnput–Check the battery voltage and all connections
AC lnput–Replace the AC power adapter and check all connections
F2| DC fan protection| Check if the fan is faulty
F3| Compressor over pressure| Disconnect the refrigerator for about 30 minutes and restart it

F4

| ****

Abnormal compressor speed

| Use the control panel to adjust the compressor speed

F5

| ****

Over temperature of the compressor

| Disconnect the refrigerator & move it to a ventilated place to cool the compressor for about 20 minutes and restart it

| | |
---|---|---|---
Dimensions| 25 14.8 14.8 inches| 25 14.8 17.2 inches| 25 14.8 19.7 inches
N.W.| 27.6 pounds (12.5kg)| 29.8 pounds (13.5kg)| 32 pounds (14.5kg)

Capacity

|

34Quart(32L)

|

44Quart(42L)

|

55Quart(52L)

Cooling Method

|

Compressor

Temperature Range| -4°F~50°F (-20°(~10°C)
Average Power Consumption|

45W

|

50W

|

55W

Voltage| AC-100V~240V       DC-12V/24V
Rated Current DC12V/24V|

3.3A/1.7A

|

3.6A/1.8A

|

3.9A/1.9A

TECHNICAL DATA

| |
---|---|---

F1

| ****

Low input voltage

| DC lnput–Check the battery voltage and all connections
AC lnput–Replace the AC power adapter and check all connections
F2| DC fan protection| Check if the fan is faulty
F3| Compressor over pressure| Disconnect the refrigerator for about 30 minutes and restart it

F4

| ****

Abnormal compressor speed

| Use the control panel to adjust the compressor speed

F5

| ****

Over temperature of the compressor

| Disconnect the refrigerator & move it to a ventilated place to cool the compressor for about 20 minutes and restart it

WARRANTY

Year Limited Warranty
EENOUR offers a limited one-year warranty on all of our products purchased new , with an original proof of purchase and where a defect has arisen as a result of faulty manufacture, parts or workman­ship during the warranty period.
Warranty Exclusions & Limitations
The warranty does not apply where damage is caused by other factors, including without limitation:

1. normal wear and tear;
2. abuse, mishandling, accident, or failure to follow operating instructions;
3. servicing or modifications of the product other than by EENOUR;
4. commercial or non-household use.
   This warranty covers the original purchaser only and is not transferable.

If you have an issue with an EENOUR product, please contact us (support@eenour.com), and we will do our best to resolve it for you.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>