JL AUDIO XDM600-6 600W 6-Channel Amplifier Owner’s Manual
- June 8, 2024
- JL AUDIO
Table of Contents
JL AUDIO XDM600-6 600W 6-Channel Amplifier
IN THE BOX
INSTALLATION CONSIDERATIONS
- Installation requires appropriate tools and safety equipment. Professional installation is recommended.
- This product is water-resistant. Do not submerge or subject to high-pressure water spray.
- Before installation, turn off the audio system and disconnect the battery system from the audio system.
- When possible, install in a dry, well-ventilated location that does not interfere with factory- installed systems.
- If a dry environment is not available, a location that is not exposed to heavy splashing may be used.
- Do not install in the engine compartment, any areas of extreme heat or where it will be directly exposed to the elements.
- Before cutting or drilling, check for potential obstacles behind mounting surfaces.
- Carefully route all system wiring away moving parts and sharp edges; secure with cable ties or wire clamps and use grommets and loom where appropriate to protect from sharp edges.
SAFETY CONSIDERATIONS
- Only use this product with 12 volt, negative- ground electrical systems.
- This product is not certified or approved for use in aircraft.
- Mount this product securely to prevent damage or injury in severe conditions.
- An appropriate fuse (or circuit breaker) at the main power wire is vital for vehicle/vessel safety and must be installed within 18 inches (45 cm) ot the positive battery connection.
- For ABYC and NMEA applications, circuit protection is required within 7 inches (18 cm) of the battery, unless the cable is in an enclosure or conduit.
- Listen to your audio system at levels appropriate for operating conditions and hearing safety.
CONNECTIONS
CONTROLS
APPENDIX A
Input Sensitivity Level Setting
Follow the steps below to adjust the input sensitivity of each amplifier
channel pair to achieve overall system balance.
SPECIFICATION
|
---|---
| Amplifier Topology| Nex D”‘Ul1ra-High Speed ClassD
| Power Supply Type| Unregulated MOSFET Switching
| Minimum Copper Powet/GNDWire| 4AWG
(Note:CCA/Copper Clad Aluminum wire is not recommended.)
| Recommended Fuse
I
| SOA
|
<1%THD+N
| 75Wx6@4Cl 15Mx3@8ClBridged|
100W)(6@2Cl
2orm x 3 @ 4 Cl Bridged
|
Rated RMS Power@125V,1
<l%THD+N
| 60Wx6@4Cl
12Mx3@8ClBridged
| 9QW)(6@20
180′-Nx3@4ClBridged
| Frequency Response| I 12 Hz-22 kHz(+O,-ldB)
|
S/NRatio (A-weighted, 20 Hz-20 kHz
noise band width) 1
|
104 dB(Referred to rated power),
84dB(Referred to 1W)
|
Damping Factor
| I >150/50Hz@4Cl,>75/50Hz@2Cl
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>