Shantou City Ourui Industrial 3711-1A Mosasaurus Toy Jurassic Ocean Dinosaur Instruction Manual
- June 5, 2024
- Shantou City Ourui Industrial
Table of Contents
Shantou City Ourui Industrial 3711-1A Mosasaurus Toy Jurassic Ocean
Dinosaur
battery installation
- Open the battery compartment: Align the screwdriver with the small contact point on the battery cover and gently press down while dragging the battery cover to open.
- Insert one 3.7V 500mAh rech argeable battery batteries into the toy battery compartmen of with correct polarity.
- Insetr 2 x 1.5V “AAA” batteries into the battery compartment of the remote controller with correct polarity
- Close the battery compartment: Tighten the screw by tuming clockwise with a phillips screwdriver.
How To Play:
-
Put the toy in water and the blue light on the top will light up, Then turn on the remote control, And the red light of the remote control will go out to complete the linking between. (Note: if the red light of the remote control keeps fiashing. The linking withis unsuccessful, Pick up toy from the water again, Turn off the
remote control, And re-operate acording to the above method, And wait for the successful linking.) -
On the left button of the remote control is the automatic demonstration of swimming process.
-
On the right button of the remote control is the water sprey. (Press once the water spray. Press again to turn off the water sprey)
Operate:
Caution:
- This product is a children’s toy that will swim in the water through the 2.4GHz wireless remote control
- This product has the function of automatic pairing, After successful pairing, It can only bge controlied one-to-one.
- While pairing, Put hte toys and remote controller as close as possible.
- The tov has the function of sensing water The motor will stop running once is taken out of the water
- The toy possesses the waterproof function
- The remote controller does not possess the waterproof function
- Distance of remote control: 30-40meters in unobstructed environment
- Operate only in caim clear water, Pools and shallow are recommended
- After each use, Wipe whit a towel and allow to dry completely
- Do not operater near concrete wails which may disturb transmission.
- Your designed for operation in fresh water, Do not submerge the water for a long time
- Maximum 10 plavers at a time
WARNING: Never allow young children to play in or around water without adult supervision. The toy can only be used in water after it is installed in accordance with the instructions
Battery Notice:
- The remote control requires two 15V AAA non-rechargeable batteries (not provided):
- The toy body requires one set of 3.7V 500mAh rechargeable batteries (provided):
- Do not charge the non-rechargeable batteries,
- Do not mix new and old or different types of batteries
- Please note the polarity when installing or replacing the battery
- Please timely take out the battery with low power
- Do not short circuit the power supply terminat
- Take out and install the rechargeable battery Loosen the main battery compartment screws with Screwdriver, open the battery cover, connect and puill out the battery connector socket in the correct direction, then close the battery cover, tighten the screws of the battery cover with screwdriver. The toy can only be used in water after it is installed in accordance with the instructions
- This rechargeable battery is non-replaceable, and the rechargeable battery can only be charged under the Supervision of adult
- Connect the supplied USB charger to the power supply with output voltage of 5.0V 500mAh; (such as: USB mobile phone charger, computer USB interface) to charge the battery.
- During charging, the Us8 charger will be slightly warm, which is normal
- The product can only be charged with the recommended USB charger, and the USB charger is not a toy
- Regularty check whether the wire, plug, casing and other parts of the USB charger and the recommended charger are damaged. If there’s any damage, stop using it before it is repaired;
- Disconnect the USB charger before cleaning the toy
- Please do not disassemble or throw the bad batteries and battery pack into fire or water to avoid accident
- The toy must not be used by children under age 3
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate thee receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>