Kruger Matz KM05004 Smartphone User Manual
- July 23, 2024
- Kruger Matz
Table of Contents
**Kruger Matz KM 05004 Smartphone User Manual
**
Product description
1 | Recipient | Receiver | Ear phone | Receptor |
---|---|---|---|---|
2 | Front camera | Front camera | Front Camera | Front Camera |
3 | Proximal sensor / light | Proximity sensor / Light sensor | Proximal sensor / | |
light | Proximal sensor / light | |||
4 | SIM/SD slots | Volume control button | SIM/SD card tray | SIM/SD card support |
5 | Volume control button | Volume control button | Volume button | button Volume |
6 | Power Button Fingerprint reader | Power button/ Fingerprint scanner | Power | |
Button Fingerprint reader | Power Button Fingerprint reader | |||
7 | Rear camera (50 M p x) | Rear camera (50 Mp x) | Rear camera (50 M p x) | Rear |
camera (50 M p x)
8| Rear camera (2 M p x)| Rear camera (2 M p x)| Rear camera (2 M p x)| Rear
camera (2 M p x)
9| Flash light| Flash| Flash| Stay
10| Headphone output| Headphone jack| Headphone output| harm chaste
11| Micro Phone| Microphone| Micro Phone| Micro Phone
12| USB-C slot| USB-C port| Port USB-C| Port USB-C
SAFETY ALERT AND CAUTIONS
Road safety comes first: Do not use a hand-held phone while driving. Use
hands-free fittings when calls are unavoidable while driving. In some
countries, dialing or receiving calls while driving is illegal! Switch off in
aircraft: Wireless devices can cause interference in aircraft. Please make
sure that your mobile phone is powered off (or switched to flight mode) during
flight.
Switch off before entering risky areas: Strictly observe the relevant
laws, codes, and regulations on the use of mobile phones in risky areas. Turn
off your mobile phone before entering a place susceptible to explosion, such
as an oil station, oil tank, chemical plant or a place where a blasting
process is under way.
Observe all special regulations: Follow any special regulations in force
in any area such as hospitals and always switch off your phone whenever it is
forbidden to use it or, when it may cause interference or danger. Properly use
your mobile phone near medical apparatuses, such as pacemakers, hearing aids
and some other electronic medical devices, as it may cause interference to
such apparatuses.
Interference: The conversation quality of any mobile phone may be
affected by radio interference. An antenna is built inside the mobile phone.
Do not touch the antenna area during a conversation, as the conversation
quality will deteriorate.
Qualified service: Only qualified personnel may install or repair phone
equipment. Installing or repairing the mobile phone on your own may bring
great danger and violates the warranty rules.
Accessories and batteries: Use only approved accessories and batteries.
Use sensibly: Use only in a normal and proper manner, and only as
indicated in this instruction manual.
Emergency calls: Ensure the phone is switched on and in service, enter
the emergency number, e.g. 112, then press the Dial key. Give your location
and state your situation briefly. Do not end the call until told to do so.
Note: Similarly to other mobile phones, this device may not support every function described in this manual due to network settings or radio broadcast operator. Some networks may not support 112 emergency calls too. Therefore, you should not rely only on mobile phones in critical situations. In case of any doubts, it is advised to contact local operator.
- Always disconnect the product from the power mains before cleaning. Clean the unit’s exterior periodically with a soft, slightly damp cloth. Do not use any chemical agents to clean this device.
- Avoid using/storing it in the strong magnetic environment.
- Protect this device from humidity, water and other liquid.
- Do not disconnect the device suddenly when formatting or uploading/downloading – it can lead to program errors.
- Do not handle the device with wet hands.
- Do not use this device if it has been damaged.
- Keep the volume at a reasonable level throughout entire time of using the speaker. To prevent damage to your hearing, do not raise the volume too high.
- Producer does not claim liability for any data loss, damage caused by inappropriate use and handling or any mechanical damage.
- Producer does not claim liability to any damages caused by inappropriate upgrade performed by the user.
- Please read this operation instruction carefully before use, and keep it for future reference.
- Before connecting the device to power supply socket, make sure the voltage indicated on the appliance corresponds to the voltage in the power supply socket.
- This product is not a toy; keep it beyond children’s reach.
CLEANING AND MAINTENANCE
Please don’t leave the phone, the battery, and the charger in the bathroom
and other high humidity places, and prevent them from rain.
- Please clean the phone, the battery, and the charger using soft and dry cloth.
- Please don’t wipe the phone using alcohol, thinner, or benzene and other chemical agents.
GETTING STARTED
STEP 1: To eject the card tray, insert card tray pin into card tray hole and push lightly until the card tray pops up.
STEP 2: Retrieve the card tray and insert the nano SIM card, nano SIM card and micro SD card as indicated (with the chip/ pins facing upwards).
STEP 3: Close the card tray.
SIM CARD/MEMORY CARD INSTALLATION
- Power off the mobile phone and disconnect it from charger before mounting SIM cards.
- Before removing memory card, make sure it has been disconnected first!
- Exercise caution when operating SIM card/ memory card, as friction or bending may damage the card.
- Keep the mobile phone and its fittings such as the SIM cards/memory cards beyond children’s reach.
- If the memory card cannot be read, please check whether it is has been inserted correctly.
- Producer does not guarantee compability with every memory card.
- Please note: Dual SIM in standby will shorten the standby time compared to single SIM.
- Make sure the battery is fully charged if it has been out of use for a long period.
NOTE: The battery is not detachable. Do not attempt to disassemble the battery.
CHARGING
Charge the smartphone using the provided USB cable. Connect the cable to USB-C
port on the device. Other end of the cable plug into provided charger or
compatible USB port.
- Make sure the phone is fully charged before turning it on for the first time.
- Use only original charging devices approved by the producer. Using other accessories may damage the device!
Overheating
While charging, the temperature of the device and the charger may get
increased. This does not affect the device’s lifespan or performance and is in
the device’s normal range of operation.
However, if there is an excessive increase in temperature or overheating, depending on the factor that caused it: device’s performance may be significantly reduced, charging process may be stopped, the device may turn off or display notification about switching off for cooling. Function available only in selected models. Important: if the device displays notification about overheat, turn it off and do not turn it back on until completely cooled down!
In case of overheat during charging:
- Disconnect the charger from the device.
- Close any running apps.
- Wait for the device to cool down, and then begin charging the device again.
If the part of the device where the USB port is placed overheats, check for damage to the connected USB cable. Replace the damaged USB cable with a new authorized cable.
The device may also overheat during operation when using several battery consuming applications or functions. In case of overheat during usage:
- Close any running apps.
- Disconnect any connectivity (Bluetooth, Wi-Fi, data transfer etc.).
- Lower the screen brightness settings.
- Wait for the device to cool down before attempting to use it again.
Safety precautions concerning operation environment
In order to maintain battery’s longevity, and to avoid overheat, follow basic precautions including provisions listed below:
- Do not use / store the device in very hot or cold environments nor expose to direct sunlight (e.g. on a car’s dashboard when using as a navigation).
- Do not place the device on surfaces that may cause overheat e.g. electric heating mat.
- Do not place near sources of heat e.g. radiators, microwave ovens, hot kitchen appliances nor high pressure containers.
- DO NOT use damaged charger or battery!
- Use only authorized chargers, batteries and cables! Using unauthorized accessories may damage the device or battery. Connecting charger with inadequate parameters may result with damage to the device and poses risk to the user.
TURN ON
Turn on: Press and hold the power button until the screen goes on.
Turn off: Press and hold the power button and the volume up button. To
turn off activating the Google Assistant with the power button, go to the
Special function menu in the Settings.
LANGUAGE
Once the phone is ON you can personalize it to your needs. To change language
go to Main Menu, open Settings, go to Language and input tab, enter Language
and select appropriate.
FUNCTION KEYS
Power button: Press and hold Power key to open the power key menu, where
you can turn off the phone (Power off) or Restart.
Volume button: Press the volume keys to change the ring volume (on the
home screen) or the earpiece volume (during a call).
Overview button: Press the button to display recently used apps menu.
Home button: Press Home to return to the home screen. Press and hold the
button to open Google Assistant function.
Back button: Goes back to previous screen or closes keyboard (if open).
LEARN MORE
For more information on this device visit:
www.krugermatz.com. | Read owner’s manual
carefully before using your smartphone. | Visit :
www.krugermatz.com website for more products and
accessories. | In case of any doubts or questions reach out to our Frequently
Asked Questions section.
Please note: illustrations and descriptions concerning operating system are
for reference only, and may vary from actual software on your device!
IMPORTANT: The producer allows the possibility for minor variations in display brightness and color between individual devices. There may be visible light or dark spots on the display. Up to 5 defective pixels are acceptable to be present on the display of the device. Above mentioned cases concerning device’s display are not covered under warranty nor statutory warranty rights.
Google and Android are trademark of Google LLC.
Lechpol Electronics Sp. z o.o. Sp.k. hereby declares that smartphone KM05004 is consistent with directive 2014/53/UE. Full text of the EU Declaration of Conformity is available at following Internet address: www.lechpol.pl.
(Waste Electrical & Electronic Equipment)
(Applicable in the European Union and other European countries with separate
collection systems) This marking shown on the product or its literature,
indicates that it should not be disposed with other household wastes at the
end of its working life. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, please separate this from other types
of wastes and recycle it responsibly to promote the sustainable reuse of
material resources. Household users should contact either the retailer where
they purchased this product, or their local government office, for details of
where and how they can take this item for environmentally safe recycling.
Business users should contact their supplier and check the terms and
conditions of the purchase contract. This product should not be mixed with
other commercial wastes for disposal.
Radio wave specification
Radio| Frequency| Max output power
GSM| B2| 33±2 dBm
B3| 33±2 dBm
B5| 30±2 dBm
B8| 30±2 dBm
WCDMA| B1| 23±2,7 dBm
B2| 23±2,7 dBm
B5| 23±2,7 dBm
B8| 23±2,7 dBm
B38| B1| 23±2,7 dBm
B2| 23±2,7 dBm
B3| 23±2,7 dBm
B4| 23±2,7 dBm
B5| 23±2,7 dBm
B7| 23±2,7 dBm
B8| 23±2,7 dBm
B20| 23±2,7 dBm
B28| 23±2,7 dBm
TTD LTE| B38| 23±2,7 dBm
B39| 23±2,7 dBm
B40| 23±2,7 dBm
B41| 23±2,7 dBm
Wi-Fi| 2.4 GHz| 17±2 dBm
Wi-Fi| 5 GHz| 15±2 dBm
Bluetooth| 2.4 GHz| 7±2 dBm
NFC| 13.56 MHz| 42 d B m @10 m