MEYER CROSS FL1477 Floor Lamp User Manual
- June 4, 2024
- MEYER CROSS
Table of Contents
FLOOR LAMP
Save these instructions
IMPORTANT SAFETY INSTRUCTIONS:
- These instructions are provided for your safety. Please read carefully and completely before beginning the assembly and installation of this lighting fixture.
- This lighting fixture is intended for indoor use only.
- Always place lighting fixture on a solid, level surface.
- For use with E26 (medium) base light bulbs only.
- To avoid the risk of fire, do not exceed the maximum wattage of 100W incandescent bulb , or 9W LED bulb , or 23W fluorescent (CFL) bulb , or 9W self-ballasted LED bulb . (Bulbs not included)
- This lighting fixture has a polarized plug (one prong is wider than the other) as a safety feature to reduce the risk of electric shock. This plug will fit in a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Never use with an extension cord unless plug can be fully inserted. Do not alter the plug. Do not attempt to bypass this safety feature.
WARNINGS:
- To reduce the risk of fire, electrical shock, or personal injury: always turn off and unplug this lighting fixture and allow it to cool before attempting to replace the light bulb.
- Do not touch light bulb while fixture is turned on.
- Keep flammable materials away from this lighting fixture.
- Never look directly at a lit bulb.
CARE INSTRUCTIONS:
- Unplug lamp before cleaning.
- Wipe clean with a soft, dry cloth or static duster.
- Always avoid the use of harsh chemicals or abrasive cleaners as they may cause damage to the fixture’s finish
PRE-ASSEMBLY:
Carefully remove all parts and hardware from carton, along with any protective
plastic packaging. The lampshade may be covered with a plastic film that
should be removed before use.
Do not discard any contents until after assembly is complete to avoid
accidentally discarding small parts or hardware.
For use with light bulbs with a E26 (medium) base.
DO NOT EXCEED THE SPECIFIED WATTAGE.
Begin with lamp laying on a soft, flat surface, taking extra care not to
damage parts.
| * Part A (Finial) may come pre-installed to
Part C (Harp). Unscrew Part A before installing
Part B (Lampshade), then reinstall Part A to secure.
---|---
NOTE: This illustration is for parts identification/orientation purposes only. For assembly, see following pages.
1. Begin with lamp laying on a soft, flat surface, taking extra care not to
damage parts.
Slide part D into part E. Screw part F, using part G, and tighten fully.
2
Slide part J up to part E and connect firmly. Make sure part E is fully inserted into part J.
3
Using part L, screw part K, through part J into part E. Carefully pull the electric cord through the parts to remove slack.
4
Slide part M up over part K and connect firmly to part J.
5
Screw part N through part M into part K. Carefully pull the electric cord through the parts to remove slack.
6
With the help of an assistant, turn floor lamp upright.
7
Stand the floor lamp upright. Attach part C to part D as shown. Lower part B over part C, secure with part A. Tighten fully by hand. Attach Part H to D as shown.
CARE INSTRUCTIONS:
- Wipe clean with a soft, dry cloth or static duster.
- Always avoid the use of harsh chemicals or abrasive cleaners as they may cause damage to the lamp’s finish.
Made in China
FL1477 rev011022EFS ME1A
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>