Schlage ND25 Heavy-Duty Exit Lever Lock Instruction Manual
- June 8, 2024
- Schlage
Table of Contents
- ND25 Heavy-Duty Exit Lever Lock
- Installation Preparation
- Install latch
- Door Thickness Adjustment
- Install chassis/outside blank rose assembly
- Install anti-rotation plate
- Install inside spring cage assembly
- Install inside rose
- Install inside lever
- Install strike
- Check lock function
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
ND25 Exit Lock
Instruction Manual
ND25 Heavy-Duty Exit Lever Lock
Installation Preparation
Door preparation:
For door preparation use the template included in the package with the lock.
For additional information, visit the website.
www.allegion.com/us.
Contact Product Support at
1-877-671-7011.
Install latch
The bevel must face toward the door stop.
Door Thickness Adjustment
- For 1³⁄4” thick doors, NO ADJUSTMENT IS REQUIRED. Continue to step 2.
- For 1⅜” thick doors, install the optional spacers (see steps 2 and 3). No further adjustment is required. Continue to step 2.
- For 1⅝”, 2”, or 2⅛” thick doors ONLY, complete the following door thickness adjustment steps.
A Remove adjustment plate by rotating counter-clockwise.
Remove door thickness insert using pin wrench.
B Reorient and replace the door thickness insert.
Door Thickness | Door Thickness Insert |
---|---|
1⅝” | |
2” | |
2⅛” |
NOTE: If door thickness insert is missing, align the adjustment plate to marks on chassis:
Door Adjustment | Thickness |
---|---|
1⅜” | Align adjustment plate with 1³⁄4” mark. Use optional spacers. |
1⅝” | Tighten adjustment plate to bottom, then rotate a half turn |
counterclockwise.
1³⁄4”| Align adjustment plate with 1³⁄4” mark.
2”| Align adjustment plate with 2” mark.
2⅛”| Align adjustment plate with 2” mark, then rotate an additional full turn
counterclockwise.
C Reinstall adjustment plate.
Tighten until door thickness insert enters notch in adjustment plate (or align
as described above).
Install chassis/outside blank rose assembly
Latch prongs fit between slide and slide clip.
Install anti-rotation plate
Align the tab with the indent on the hub.
Install inside spring cage assembly
Install inside rose
Install inside lever
Firmly push on until lever catch engages.
Install strike
Check lock function
Customer Service
1-877-671-7011
www.allegion.com/us
Revision History| Revision Description:
C v Reactivate this item for use with ND25. No new instruction needed for
Broccoli project implementation. No artwork or spec changes.
---|---
A| B| C| D| E| F
066546| 069086| 089268| | |
Material
White Paper| Edited By| Approved By| EC Number| Release Date
P. Bockelman| M. Sasso| 89268| 3/16/21
Notes
1.printed two sides
2.printed black
3.tolerance ± .13
4.printed in country may vary
5.drawings not to scale| Title
Installation Instruction, ND25
Creation Date
03-23-16| Number
P517-382| Revision
C
Created By P. Bockelman| Activity
3899 Hancock Expwy
Security, CO 80911| O Allegion 2021
Software: InDesign CS6
© Allegion 2021
Printed in U.S.A.
P517-382 Rev. 03/21-c
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>