SKYDANCE PK1(G) Rotary Glass Panel RF Remote Controller User Manual

SKYDANCE PK1(G) Rotary Glass Panel RF Remote Controller

Features

• Apply to a single color, dual-color or RGB LED controller.
• Rotate the knob to change RGB color, color temperature or brightness, and support long press or twice click operation.
• Each remote can match one or more receivers.
• CR2032 battery powered.

Technical Parameters

Input and Output

Output signal| RF(2.4GHz)
Working voltage| 3VDC(CR2032)
Working current| ＜5mA
Standby current| ＜10μA
Standby time| 1 year
Remote distance| 30m(Barrier-free space)
Safety and EMC

EMC standard (EMC)| ETSI EN 301 489-1 V2.2.3

ETSI EN 301 489-17 V3.2.4

Safety standard(LVD)| EN 62368-1:2020+A11:2020
Radio Equipment(RED)| ETSI EN 300 328 V2.2.2
Certification| CE, EMC, LVD, RED
Environment

Operation temperature| Ta: -30 OC ~ +55 OC
IP rating| IP20

Warranty: 5 Years

Mechanical Structures and Installations

Replace battery:

Typical base as below:

Installation diagram:

Knob function

PK1(G) Single color dimming remote

• Push: Turn on or off the light.
  After turning on the light:

• Rotate: Rotate the knob to adjust brightness(2.5 turns, 50 levels).

• Long push(1-6s): Continuous 256 levels of brightness adjustment.

PK2(G) Color temperature remote

• Push: Turn on or off the light.
  After turning on the light:

• Rotate: Rotate the knob to change the color temperature or brightness (2.5 turns, 50 levels).

• Push twice: Switch between color temperature or brightness adjustment.

• Long push(1-6s): Continuous 256 levels of brightness adjustment.

PK3(G) RGB remote

• Push: Turn on or off light.
  After turn on light:

• Rotate: Rotate knob to change RGB color (3 turns, 60 colors) or brightness (2.5 turns, 50 levels).

• Push twice: Switch between RGB color or brightness adjustment.

• Long push(1-6s): Continuous 256 levels brightness adjustment.

Match Remote Control (two match ways)

The end users can choose suitable match/delete ways. Two options are offered for selection:

Use the controller’s Match key

Match:
Short press the match key and immediately push the knob. The LED indicator fast flash a few times means the match is successful.

Delete:
Press and hold the match key for 5s to delete all match, The LED indicator fast flash a few times means all matched remotes were deleted.

Use Power Restart

Match:
Switch off the power, then switch on the power, and repeat again. Immediately push the knob 3 times.
The light blinks 3 times means the match is successful.

Delete:
Switch off the power, then switch on the power, and repeat again. Immediately push the knob 5 times.
The light blinks 5 times means all matched remotes were deleted.

Safety information

1. Read all instructions carefully before you begin this installation.

2. When installing battery, pay attention to the battery positive and negative polarity. A long time without the remote control, remove the battery.
   When remote distance becomes smaller and insensitive, replace the battery.

3. If no response from the receiver, please re-match the remote.

4. Gently handle remote, beware of falling.

5. For indoor and dry location use only.

www.iskydance.pl

References

• Sklep ELED - oświetlenie LED na miarę Twoich potrzeb

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>