Chargers C35 Fast Wireless Charger User Manual
- June 4, 2024
- Chargers
Table of Contents
Chargers C35 Fast Wireless Charger
Thank you for purchasing and using this product! Please read this operation instruction carefully before using this product
Product Specification
Fast Wireless Charger
- Input: 5V=2A/9V=2A
- Output: 5W/ 7.5W/ 10W
- Charging Efficiency: 70%
Applicable Devices
Compatible with all devices with Qi Standard For all other phones without Qi Standard, compatible if equipped with wireless receivers.
The LED Light turns red during wireless charging to indicate a charging failure. The following situation can cause failures, like charging slowly, stop charging. over-temperature for charging position.
- The adapter is not run up to standard (No PC USB output power supply).
- The charging cable is not up to standard.
- The phone case is too thick (within 2mm thickness phone case recommended ).
- The built-in wireless charging receiver position does not coincide with the wireless charger coil position.
- There is a metal/magnet on the back of the cell phone or phone case.
- The smartphone does not support wireless charging functions.
Attention
- Please keep the charger away from water or other liquid.
- If you need to clean the charger, please make sure it is not connected to the power supply.
- Operating temperature: -20-45C.
Step to install an air vent
- Press the button of the clip to fix it, then adjust the angle and tighten the fixed nut
- Installation completed.
Step to install suction cup
Adjust the angle of suction cup and empty air.
- Tear off the red protective film and stick it on the dashboard
- Paste the suction cup on the 3M auxiliary fixing plate, press it for 1 minute and let it stand for 1 hour.
- Press the lever
- Adjust the appropriate angle
Installation completed.
Step to use wireless charger
-
Input: Connect the wireless charger and car adapter with the charging cord.
Please use a QC3.0/PD adapter so that the charging will enter the fast charging mode. -
Place smartphone.
Both sides of the clip open automatically after being powered, putting on a smartphone, the clip close automatically to tighten the smartphone. -
Take off your smartphone.
Press the key, the clip opens automatically, and take your phone out. -
LED indicator light shows the working status:
-
White LED Light: Standby.
-
Blue LED Light: Charging normally.
-
Red LED Light: Charging abnormally.
FCC Requirement
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. This
device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Note : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interterence in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver isconnected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>