datacolor S4SR100 Spyder Print Profiling Tool User Guide
- June 4, 2024
- datacolor
Table of Contents
datacolor S4SR100 Spyder Print Profiling Tool
QUICK START GUIDE
What You Get
- Spyder Print spectrocolorimeter
- Sensor Base
- Spyder Guide
- USB cord
- Welcome Card with download instructions and serial number
System Requirements
- USB port
- Windows 7 32/64, Windows 8.0, 8.1 32/64, 10 32/64
- Mac OS X 10.7 or higher
- Monitor Resolution 1280×768 or greater, 16-bit video card (24 recommended), 1GB of available RAM, 500MB of available hard disk space
- Internet connection for software download
Support
support.datacolor.com
-
Step 1 – Install and Activate
Install the Spyder Print software from the Datacolor Website. After the installation is complete, plug in your Spyder Print and launch the software to begin the activation and registration process. This will automatically start your warranty. Use the Serial Number on your welcome card to activate your software. -
Step 2 – Printer Settings
Change the settings for the printer you want to profile to:- Landscape orientation
- 0.25 in (.635 cm) margins
- Single sided
- Turn off any color management.
-
Step 3 – Print Target
Follow the on-screen instructions to specify the printer, paper type, and select the target to be printed.
It is recommended to wait 15-30 minutes for the ink to dry before moving further. -
Step 4 – Calibrate and Measure
Continue to follow the on-screen instructions to calibrate the Spyder Print. Then begin to measure the printed target. -
Step 5 – Apply Printer Profile
After the profile has been created, evaluated, and saved, remember to select this profile in the printer dialog box of the application you are using to apply it to your prints.
RIGHTS: © Copyright Datacolor. All rights reserved.