bol Veloretti Maxi Kinderfiets 16 Inch Rood Instruction Manual

: June 9, 2024
: bol

Table of Contents

What you’ll need
IMPORTANT!
Assembly instructions
- STEP 1 – Unboxing
- STEP 2 – Mount Kickstand
STEP 3 – Install Pedals
- STEP 4 – Insert & Adjust Handlebar Stem
- STEP 5 – Install Hand Brake
OPTIONALL
Read User Manual Online (PDF format)
Download This Manual (PDF format)

bol Veloretti Maxi Kinderfiets 16 Inch Rood

What you’ll need

You will need wrench 15 out of your own toolbox.

IMPORTANT!

This manual contains important information about the assembly and safety of our bikes. Please read the manual carefully and pay attention to every step.

If you’ve got any questions or uncertainties during the assembly, please contact us or your local bike shop immediately!

Assembly instructions

Congrats with your purchase! Within this Box you will find the brand new Vaporetti Maxi! Packaged with care and almost completely assembled. Just follow the next few steps and your kid will be ready to hit the streets in style!

STEP 1 – Unboxing

Start off by carefully getting the Maxi out of the box and removing the packaging material (Fig. 1).

STEP 2 – Mount Kickstand

Next you’ll attach the kickstand using Allen key 8, after which you can place the
bike in an upright position (Fig. 2).

STEP 3 – Install Pedals

The pedals are marked “L” or “R” on the end face of each spindle. The right pedal (“R”) goes on the right side of the bike (the chain side). Using your hand, begin threading the right pedal into the right crank arm by turning the pedal spindle clockwise ( Fig. 3 ).

Be sure the pedal is placed perpendicular (at a 90 angle) into the crank arm. If the pedal does not easily tighten by hand, it may not be at a straight 90~ angle, and you’ll risk permanent damage by cross threading. So if the pedal does not thread on easily, remove it and try again.
Once the pedal has been threaded on by hand, use wrench 15 for tightening.
Fasten the pedal as tight as you can. The procedure for the left pedal is the same, except you will need to rotate the pedal counter clockwise in order to tighten it (Fig. 3.1).

STEP 4 – Insert & Adjust Handlebar Stem

Insert the handlebar stem into the steerer tube. Lift the handlebar stem into the preferred position (Fig. 4).

Now use Allen key 6 to tighten the bolt on top of the handlebar stem. Turn it clockwise, as tight as you can (Fig. 4.1).

With the stem securely tightened, you can now adjust the handlebar angle.
On the front of the handlebar stem, there is a 6mm bolt with which you can adjust the angle of the handlebar. Use Allen key 6 to loosen this bolt (counter clockwise) so the handlebars can rotate. Then set the bars to your desired level, and retighten the bolt (clockwise) as tight as you can (Fig. 4.2).

STEP 5 – Install Hand Brake

Place the cable into the cable unit by pinching the brake pads together to the rim (Fig. 5).

Make sure you put the cable completely through the hole, so it can’t disengage by itself **(Fig. 5.1).