Bol RX-DQ Aluminum Fingerprint Lock Instruction Manual
- May 15, 2024
- bol
Table of Contents
Bol RX-DQ Aluminum Fingerprint Lock
Lock Operation
Download the QR code:
Unlocking Methods
Four independent unlocking methods:
- Password: press the key of *, the screen will be lighted and powered. Then put in the password and press. When you hear the music, the door will be opened. The password capacity is 100 groups.
- Fingerprint: open the slide cover, and put your finger on the fingerprint reader. When you hear the music, the door will be opened. The fingerprint capacity is 100 pieces.
- Card: keep the opening card close to the card reader, when you hear the music, the door will open. The card capacity is 100 pieces.
- Mechanical keys.
Operation Instructions
- Initialization: Press the reset button on PCB for 5 times constantly, lock would turn into default status: Master password: 123456;
- Changing the administrator password: the default administrator password is 123456. Press “* + + administrator password + ” to enter the programming mode. Next, press 8 + and put in a new administrator password ending with pressing . Then put in the administrator password second time and end with pressing ****. The setting will be finished when you hear a long sound. This administrator password can also open the lock.
- Adding a guest password: Press “* + + administrator password + ” to enter the programming mode. Next, press 7 + and put in a 2-digit user-defined password number (from 01 to 99, should be registered in the form). Then put in a guest password ending up with pressing the and repeat this again. The setting will be finished when you hear a long sound.
- Adding a guest fingerprint: Press “* + + administrator password + ” to enter the programming mode. Next, press 6 + ****and put in a 2-digit user-defined number for the guest fingerprint (from 01 to 99, should be registered in the form). Then put your finger on the fingerprint scanner till you hear a long sound. The setting is complete.
Installing lock mortise
Following the picture below, take the lock cylinder with its connecting line
on the upper side to install in the cylinder pore on the door. Please do not
make the 4P line in the door. Use 4 flat countersunk head tapping screws to
fix the cylinder. Then take the mechanical lock with this key pore outwards to
install in the cylinder pore and use FM 5 * 65 Machine Screws to fix it. Then
use the mechanical key to exam whether it can be open or not.
Installing the front and back lock panels
Before installing the lock body, please check if the handle springs fall off,
and put the handle square shafts into the lock cylinder. Please notice the
directions of opening left and opening right: the downwards arrow is for
opening right and upwards for left. As showing below, the 3P line connects the
back body and the square shaft of the deadbolt should be put in the pore of
the cylinder. Then fix the body with 4 pieces FM 5 * 55 Machine Screws. And
next load the batteries and fix the back covers.
DIMENSION
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>