BRETFORD TVC16PAC-CK CUBE Carts User Guide

BRETFORD TVC16PAC-CK CUBE Carts

Technical Specifications

• CAPACITY                  slot width = 1.4”

  • TVC16PAC-XXX: 1 shelf     16 devices
  • TVC32PAC-XXX: 2 shelves 32 devices

• COMPATIBILITY
  Designed for various sized laptops & chromebooks, yet versatile enough to support most tablets. Uses the device manufacturer supplied AC power cord and adapter.

• OUTSIDE DIMENSIONS: 30” W x 26.5”D x 37.5”H

• WEIGHT: TVC16PAC-XXX 134 pounds empty 259 pounds with 16 ea 5 lb devices + an allowable 45 lbs in the bottom shelf area

  • TVC32PAC-XXX 143 pounds empty 303 pounds with 32 ea 5 lb devices

• POWER MANAGER Digital

• POWER REQUIREMENTS 120Vac, 50/60Hz, 12A

• SHIPPING Ships fully assembled, ready to load devices

• WARRANTY For product specific warranty information, please visit: bretford.com/warranty

General Use

SETTING THE COMBINATION LOCK
Your new CUBE Cart comes equipped with a resettable Combination Padlock. You can program the lock with your own combination. The lock starts with 0-0-0-0. Follow the directions with the look for changing the combination. Remember to depress the shackle before disengaging it from the lock.

CUBE CARTS

Device Storage & Cable Management

1. At the back of the cart, use the key from the hardware pack to unlock the rear access panel.
2. The two keys included in the hardware pack are for the person(s) responsible for managing the computer adapters and cable sets, through the rear access panel.
3. Lift the rear access panel off of the chassis. This exposes the power outlet modules for the shelves.
4. Starting in the rear of the cart with the rear access panel panel removed, insert a power adapter in the storage bin for the associated device storage shelf (top or bottom).
5. Measure the amount of cable necessary to reach from the power adapter located in the bin to the front of the cart (over the AC outlet box, from the back to the front of the cart, through the cable management slots that are integrated into the plastic dividers.)
6. Leave sufficient slack for the power connector to plug into the device.
7. Plug the device AC adapter plug into one of the outlets nearest to where the power adapter is located in the bin.
8. Repeat the above process for the total number of devices’ power adapters & cable sets.
9. In the front of the cart, insert a device into each of the slots, and plug in the power connector to each device.
10. Replace the Rear Access Panel and lock the panel using the key from the Hardware Pack.
11. Place the cart near a wall outlet and plug the cart in.
12. Turn on the power switch – located in front of the push handle
13. In the TVC32PAC-XXX CUBE Cart for 32 devices, once the cart is turned on, the power manager begins rotating power to the power strips every 5 minutes. This allows efficient charging of the devices in the cart from one single 15 amp circuit.

“WARNING”: This Safe User Label is attached to the side of the cart, warning that the cart may tip over if transported incorrectly, which could cause injury.

• Do not allow children under 16 to move cart. Only adults should move this cart.
• Move the cart slowly
• Apply moving force on the narrow dimension.
• Always push using the handles. Push the cart, do not pull it.

“WARNING”: Relocating audio and/or video devices to a cart not specifically designed to support audio and/or video devices may result in death or serious injury due to the cart collapsing or over turning onto a child.
“WARNING”: Death or serious injury may occur when children climb on a cart. A remote control or toys placed on the cart may encourage a child to climb on the cart and as a result, the cart may tip over on to the child.

Safe Use Instructions

• This cart may be intended for institutional use.
• The socket outlet shall be installed near the cart and shall be easily accessible.
• Make sure all devices do not exceed the maximum load rating of 12 amps.
• Power strips inside cart are intended only for charging compatible devices. Any other use may cause overload.
• Do not move cart by pulling the power cord. Before moving cart from one room to the next, wrap power cord around the cord winder located on the side of the cart.
• Do not plug the cart in if the switch, receptacle(s), or power cord has been damaged. Contact Bretford or a qualified electrician before attempting to make any type of electrical repair or parts replacement.
• Engage locking casters when cart is not in transit.
•  Do not block ventilation holes on cart. Proper air flow is required for safe operation.
• Cart is not designed to be operated by a child or student. Adult operation and supervision is recommended at all times.
• Liquids should not be stored in, set on or placed inside the cart.
• Only clean the surfaces of cart with soft dry cloth. Do not use liquid or spray or abrasive cleansers. Use only disinfecting wipes containing no bleach.
• Product is for indoor use only.
• User can plug in up to 32 devices at one time.
• Turn power switch off before plugging in devices
• Turn power switch off before unplugging the cart.
• Do not pull the cart. Always push cart using the handles. Use extra caution on ramps and thresholds.
• Do not plug the power cord into another extension cord or re-locatable power tap.
• Be sure to turn power switch off and unplug cart before moving to a different location.
• Ensure casters are locked before opening the cart doors.
• Be sure to lock up cart in a secure environment after every use.
• Do not share the lock combination code with any unauthorized persons.

www.bretford.com

References

• Warranty Registration - Bretford
• Bretford - Charging Solutions to Power & Manage Mobile Users

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>