FORTIN RFK 3641 Remote Kit User Guide

FORTIN RFK 3641 Remote Kit

Instruction

BUTTON : COMMAND TIME:  PRESSED : DESCRIPTION

1. LOCK 1 SECOND Locks all doors, arms the anti-theft system and activates the Alarm (if available).
2. PANIC 3 SECONDS Press LOCK for 3 seconds to activate the Panic.
3. UNLOCK 1 SECOND Unlocks all doors, disarms the anti-theft system and deactivates the Alarm (if available).
4. START 3 SECONDS Remote start the vehicle. Press START again to reset the runtime.
5. TRUNK 3 SECONDS Opens the trunk, and deactivates the Alarm (if available). The Alarm ignores the trunk zone until it is closed.
6. STOP 1 SECOND Cancel the remote start sequence.
7. AUXILIARY1 1 SECOND Activates the auxiliary1 (if available).
8. AUXILIARY2 1 SECOND Activates the auxiliary2 (if available).
9. 3 SECONDS UNTIL THE RED LED TURN ON Disable all the remote’s buttons for safety. The RED LED will come on whenever a button is pressed when the remote is DISABLED.
10. 3 SECONDS UNTIL THE GREEN LED TURN ON Enables the buttons on the remote.

REMOTE STARTING

When leaving the vehicle it is recommended that the driver pre-set the climate controls in preparation for a later remote start. To remote start the vehicle :

• To remote-start the vehicle press the START button for approximately 3 second
• Approximately 5 seconds later the engine will crank and run for the selected runtime (15 minutes by default).

If the vehicle fails to start on the first attempt, the Remote-Starter will wait 3 seconds before it will attempt to start the vehicle again. The Remote- Starter will attempt to start the vehicle 2 times (default) before giving up. (See Failed Remote Start, on the complete user guide). RUNTIME : On gas engines the Remote-Starter can run the vehicle for either 15 (default), 3 or 7 minutes. On diesel engines either 30 (default), 6, or 15 minutes.

REMOTE STARTING FROM FACTORY KEY FOB

IF OPTION AVAILABLE. To remote start the vehicle with the factory key fob :

PRESS LOCK 3 TIMES (By default) or PRESS LOCK UNLOCK LOCK. Remote-start the vehicle.

WHEN SERVICING THE VEHICULE

Valet Mode disables the remote starter and alarm. Whenever the vehicle is being serviced, repaired or the vehicle is parked indoors; it is mandatory that Valet Mode be enabled to prevent an accidental remote start.

FROM VALET SWITCH

• STEP 1
  Turn the vehicle ignition to (ON/RUN) position. The vehicle does not need to be started.

• STEP 2
  Within 10 seconds press and release the valet button 3 times.

FROM THE REMOTE

• Press and release the FUNCTION button, and than press simultaneously the LOCK and UNLOCK.

• VALET MODE ENABLED: The LED is ON VALET MODE DISABLED: The LED is OFF

KEY TAKEOVER AFTER REMOTE STARTING*

KEY TAKEOVER FOR STANDARD KEY VEHICLE*

• STEP 1 Do not press the foot brake (the engine will shut down).
• STEP 2 Insert the key into the ignition and turn to ON position.
• STEP 3 Press the foot brake.

**KEY TAKEOVER FOR PUSH-TO-START VEHICLE***

• STEP 1 UNLOCK the doors with either the OEM remote, the remote-starter remote or the proximity remote*.

FORD / HYUNDAI / INFINITI / KIA / MAZDA / NISSAN / SUBARU*

• STEP 2   Enter the vehicle with the SMART-KEY.
• STEP 3 Do not press the foot brake.
• STEP 4 Press and release the Push-to-Start button once.
• STEP 5 Press the foot brake.
• STEP 6 The vehicle can now be put in to gear and driven. If the Smart- Key is not detected the vehicle will shut down.

ACURA / HONDA / LEXUS / SCION TOYOTA *

• STEP 2 The module will shut down the vehicle as soon as the drivers door is opened.

AUDI / BMW / CHRYSLER / GMC*

• STEP 2 Press the foot brake.
• STEP 3 The vehicle can now be put in to gear and driven.

*The remote starter key takeover may vary by vehicle, ask your adviser or technician for details.

**REMOTE START DIAGNOSTICS***

Parking Light flashes (before starting) :
3x Ready mode disabled 3x Door open – zone 3
4x Valet mode activated (The LED is on)
4x Shock sensor – zone 4
5x Hood open – zone 5
5x Hood open 6x Trunk open – zone 6

Parking Light flashes (after Shutdown) :
*The parking light diagnostics can not be used on some vehicles equipped with automatic lights.
1x Normal stop (Brake, Park Brake)
3x Runtime expired or shut down by transmitter
4x No tachometer signal
5x Hood open
6x Fail to start

RANGE
Up to 800m/2800ft

BATTERY
BATTERY REQUIRED : 1x CR2032
AVERAGE BATTERY LIFE : 24 months

THANK YOU FOR PURCHASING THIS REMOTE-STARTER/ALARM SYSTEM. WE RECOMMEND THAT YOU DOWNLOAD AND THOROUGHLY REVIEW THE COMPLETE USER MANUAL FOR MORE INFORMATION ABOUT THE REMOTE STARTER / ALARM SYSTEM AT :
evoremotestart.com/RFK3641

CAUTION
IT IS THE RESPONSIBILITY OF THE REMOTE CAR STARTER OPERATOR TO :

• ensure that the vehicle is parked in a safe and responsible manner.
• ensure that the vehicle is not remotely started indoors (garage, underground parking).
• ensure that the vehicle is not remotely started with a passenger inside.
• ensure that the vehicle is not remotely started with a window or the roof open.
• ensure that the gearshift lever is in the NEUTRAL position and the parking brake is engaged on manual transmission in order to avoid accidents upon remote starting.
• when leaving the vehicle, ensure that the gearshift lever is in the “PARK” position for an automatic transmission in order to avoid accidents upon remote starting. Make sure that the vehicle cannot start in “Drive” position.
• ensure that the remote starter is disabled or put into valet mode before servicing. When servicing the vehicle, download the complete user guide for more information.

References

• evoremotestart.com/RFK3641

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>