Hamron 023676 Light Bar Led User Manual
- June 9, 2024
- HAMRON
Table of Contents
Hamron 023676 Light Bar Led
Instruction
Jula AB reserves the right to make changes to the product. Jula AB claims
copyright on this documentation. It is not allowed to modify or alter this
documentation in any way and the manual shall be printed and used as it is in
relation to the product. For the latest version of operating instructions,
refer to the Jula website.
WWW.JULA.COM
@ JULA AB 2022-08-11
JULAAB
BOX 363. 532 24 SKARA, SWEDEN
SAFETY INSTRUCTIONS
WARNING!
- The product must only be used within its rated voltage range, 9 to 36 VDC.
- The light source gets hot when the product is switched on. Allow the light source to cool for at least 30 minutes before touching or handling it.
- Make sure there is a free flow of air through the cooling fins on the light source and keep the fins clean.
SYMBOLS
- Read the instructions.
- CE Approved in accordance with the relevant directives.
- Recycle discarded product in accordance with local regulations.
TECHNICAL DATA
- Output 150W
- Colour temperature 6000 K
- Luminous flux 14000 Im
- Protection rating IP68
- Rated voltage 9-36 V DC
- Cord length 512 mm
- Range 470 m (1 Lux) 940 m (0.25 Lux)
- Size 514 x 54 x 61.5 mm
- Weight 2 kg
DESCRIPTION
FIG.1
PARTS
- Bottom fastener
- Side fastener
FIG. 2
INSTALLATION
PREPARATIONS
- Read these instructions carefully before installation and save them for future reference.
- Always comply with the applicable laws and regulations for the installation and use of auxiliary lights.
- Disconnect the negative/chassis earth cable from the battery before connecting the product, to avoid damage from short-circuiting during the installation.
- Follow as far as possible the existing cable routing for installation of new cables. Carefully fasten the cable and any excess length with cable ties, insulating tape or the equivalent.
- Cable grommets through the firewall should be at a safe distance from moving parts.
INSTALLATION
- Drill screw hole with a diameter of 8.5 mm in the surface where the product is to be installed.
- Put the screw in the hole, put on the lock washer and tighten the nut.
- The product can be mounted with side or bottom fastener.
Cable colour coding
Earth wire (black)
Red wire: + for headlight
White wire:+ for parking light (white light, R148 certified) Yellow wire: +
for parking light (amber light)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>