MGC ANC-6000 Audio Network Controller Board Instruction Manual
- June 2, 2024
- MGC
Table of Contents
ANC-6000
Audio Network Controller Board
Installation Instructions
Module Mounting Locations
The ANC-6000 Audio Network Controller board is mounted in the center position
over the FX-6000MNS-CH main fire alarm board as shown in Figure 1. If a
TNC-5000 Telephone Controller board is used, it is mounted over the ANC-6000.
Figure 1 Mechanical Installation for the ANC-6000 Audio Network Controller
Board
Figure 2 ANC-6000 Audio Network Controller Board Layout
DIP Switch Settings for SW1 on the ANC-6000 Board
Addresses available for the ANC-6000 (per node) are set as noted in the
following table.
ANC-6000 Address Setting (DIP SWITCH SW1)
ANC-6000
|
ADDR
| SW1-1| SW1-2| SW1-3| SW1-4| SW1-5| SW1-6| SW1-7|
SW1-8
---|---|---|---|---|---|---|---|---|---
1| ON| OFF| OFF| OFF| OFF| OFF| OFF| OFF
2| OFF| ON| OFF| OFF| OFF| OFF| OFF| OFF
3| ON| ON| OFF| OFF| OFF| OFF| OFF| OFF
4| OFF| OFF| OFF| OFF| OFF| ON| OFF| OFF
5| OFF| OFF| OFF| OFF| OFF| ON| OFF| ON
6| OFF| OFF| OFF| OFF| OFF| ON| ON| OFF
7| OFF| OFF| OFF| OFF| OFF| ON| ON| ON
ANC-6000 Wiring
The auxiliary audio input has a maximum input of 1 VRMS. The transformer is
isolated on the ANC-6000.
Connect an audio source, for example background music or paging, to the SIG
terminal. Connect a normally open relay and 3.9 kΩ resistor to the CTL
terminal as shown in Figure 3. Short the relay to activate the auxiliary
audio.
LT-6685 Rev 0 Nov 2022 Page 3 of 3
Documents / Resources
| MGC
ANC-6000 Audio Network Controller
Board
[pdf] Instruction Manual
ANC-6000 Audio Network Controller Board, ANC-6000, ANC-6000 Network Controller
Board, Audio Network Controller Board, Network Controller Board, Audio Network
Board, Audio Controller Board, Audio Board, Controller Board, Board
---|---
| MGC
ANC-6000 Audio Network Controller
Board
[pdf] Instruction Manual
ANC-6000, Audio Network Controller Board, ANC-6000 Audio Network Controller
Board, Network Controller Board, Controller Board, Board