MGC QAD-6425-25V Amplifiers Instruction Manual
- June 9, 2024
- MGC
Table of Contents
QAD-6425-25V Amplifiers
Instruction Manual
QAD-6425-25V Amplifiers
Components on the amplifiers should be facing right when inserted into the
amplifier card cage backplane. Place all amplifier modules from left to right
in slot positions one to four in each card cage. Refer to Figures 1 and 2.
For wiring instructions, see LT-6683.
Attention: Power should be disconnected before removing and inserting
modules and cables.
Attention: Improper installation or excessive force will damage the
backplane and amplifiers being installed or removed.
Installing QAD Amplifier Modules
- Hold the amplifier by the front metal face. Do not handle, push or pull any of the components on the amplifier as this will damage those components.
- Line up the amplifier with the runners on the card cage and slide the amplifier back to the point where the amplifier almost touches the pins on the backplane.
- Press the amplifier firmly from the front face toward the backplane until the amplifier is in position with the connector on the backplane and the amplifier snaps into place
- Screw down the amplifier with the top and bottom screws provided on the amplifier card.
Removing the
QAD Amplifier Modules
- Unscrew the two screws holding the amplifier in place. Do not handle, push or pull any of the components on the amplifier as this will damage those components.
- Place the forefinger of one hand on the top section of the amplifier metal front plate and the forefinger of the other hand on the bottom edge of the amplifier metal front plate.
- Carefully pull the amplifier forward until the amplifier connector is disconnected from the backplane connector.
- Holding the amplifier firmly by the front metal, slide the amplifier forward and completely remove it from the card cage.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>