LANCOM GS-2326+ Medium Sized Networks Reliable Switch User Guide
- June 4, 2024
- LANCOM
Table of Contents
LANCOM GS-2326+ Medium Sized Networks Reliable Switch
Hardware Quick Reference
➀ Configuration interface
Connect the serial interface (Console) via the included serial configuration
cable to the serial interface of the device you want to use for configuring /
monitoring the switch.
➁ TP Ethernet interfaces
Use Ethernet cables to connect the interfaces ETH 1 to ETH 24 to your PC or a
LAN switch.
➂ TP Ethernet interfaces (combo ports)
Use Ethernet cables to connect the interfaces ETH 25 and ETH 26 to your end
device or another LAN switc
➃ SFP interfaces (combo ports)
Insert suitable LANCOM SFP modules into the SFP combo ports 25 and 26. Choose
cables which are compatible with the SFP modules and connect them as described
in the module’s documentations.
➄ Power connector and grounding point (device back side)
Supply power to the device via the power connector.
Please use the IEC power cable supplied (separately available for WW devices).
➅ ATTENTION: High touch current possible! Connect to earth before
connecting the power supply.
➀ System / Link/Act/Speed
System: off| Device powered off
System: green| Device operational
Link/Act/Speed: green| Port LEDs show link / activity status or port speed
➁ Mode/Reset button
Short press| Port LED display switch
5 seconds pressed| Restart of the device
10 seconds pressed| Reset and restart of the device
➂ TP Ethernet ports
Off| Port inactive
Green| Link 1000 Mbps
Orange| Link ≤ 100 Mbps
➃ SFP ports
Off| Port inactive
Green| Link 1000 Mbps
Orange| Link ≤ 100 Mbps
Before initial startup, please make sure to take notice of the information regarding the intended use in the enclosed installation guide!
Operate the device only with a professionally installed power supply at a nearby power socket that is freely accessible at all time
|
Please observe the following when setting up the device
→The power plug of the device must be freely accessible.
→For devices to be operated on the desktop, please attach the adhesive rubber
footpads
→Do not rest any objects on top of the device
→Keep all ventilation slots on the side of the device clear of obstruction
→Mount the device into a 19” unit in a server cabinet using the provided
screws and mounting brackets.
→Please note that support service for third-party accessories is excluded.
---|---
This product contains separate open-source software components which are subject to their own licenses, in particular the General Public License (GPL). The license information for the device firmware (LCOS) is available on the device‘s WEBconfig interface under “Extras > License information“. If the respective license demands, the source files for the corresponding software components will be made available on a download server upon request.
Hereby, LANCOM Systems GmbH | Adenauerstrasse 20/B2 | D-52146 Wuerselen, declares that this device is in compliance with Directives 2014/30/EU, 2014/35/EU, 2011/65/EU, and Regulation (EC) No. 1907/2006. The full text of the EU Declaration of Conformity is available at the following Internet address:www.lancom-systems.com/doc
