AMP Lighting ASPL-3029-B-BZ and ASPL-3029-P-BK Low Voltage Landscape Lighting Installation Guide
- June 3, 2024
- AMP Lighting
Table of Contents
AMP Lighting ASPL-3029-B-BZ and ASPL-3029-P-BK Low Voltage Landscape
Lighting
INSTALLATION & MAINTENANCE GUIDE
Important Safety Instructions: Read Before Installation
This luminaire is intended for installation in accordance with local codes and
the National Electric Code (NEC). Failure to adhere to these codes and
instructions may result in serious injury, and property damage and void the
warranty.
These instructions do not intend to cover all variations in installation,
operation maintenance or mounting situations. Please note that these solar
fixtures are equipped with built-in photocells, so they will not turn on until
it is dark enough. These fixtures will also require plenty of sunlight to
function properly. It’s best to have the fixture in an area where the sun will
get to it at all times throughout the day and where no ambient lighting will
affect the photocell at night. If your fixture is not functioning at night, be
sure that the on/off button has been engaged. See step one for details.
Important Safety Instructions
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS Lighted lamp
is HOT!
WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.
- The lamp gets HOT quickly!
- Do not touch the hot lens, guard or enclosure.
- Keep lamps away from materials that may burn.
- Do not touch the lamp at any time. Use a soft cloth. Oil from the skin may damage the lamp.
- Do not operate the luminaire fitting with a missing or damaged shield.
Package Contents
- (1) Fixture Body
- (4) Self-tapping Screws
Product Dimensions
Test Solar Light
Slide the ON/OFF switch of the fixture to the “ON” position. Cover solar panels completely by using a dark material. The fixture will light up when the solar panel is covered and turn off when it is uncovered. Now you can proceed to the next steps of installation knowing the fixture is ON.
Install Fixture to Post
Attach the fixture onto a 4”x 4” square wood post and secure it with self- tapping screws. Tighten with a screwdriver.
Remove Solar Panel
Using a screwdriver, remove the screws from the corners to remove the solar panel from the fixture body.
Replace Battery
Disconnect the quick connector by pressing the tabs on the side. Remove the old battery by removing the two screws. Replace the battery and secure it with the previously removed screws. Then connect the tabs of the quick connector back together. Reinstall the solar panel to the fixture body and secure it with previously removed screws. Specifications and product details are subject to change without notice. Copyright 2021, AMP® Lighting, Lutz FL USA 33549 All rights reserved. customersupport@amplighting.com 813.978.390
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>