AMP Lighting VAC-SM9-BBZ Low Voltage Landscape Lighting Installation Guide

AMP Lighting VAC-SM9-BBZ Low Voltage Landscape Lighting Installation Guide

Important Safety Instructions: Read Before Installation

This luminaire is intended for installation in accordance with local codes and the National Electric Code (NEC). Failure to adhere to these codes and instructions may result in serious injury, property damage and void the warranty.

These instructions do not intend to cover all variations in installation, operation maintenance or mounting situations.

1. Make sure the power is turned OFF before installing or servicing this luminaire.
2. WARNING: risk of electrical shock. Install all luminaires 10 feet (3.05M) or more from pool, spa or fountain.
3. Check the bungee straps every year to make sure they still fit the tree while it is growing.

Package Contents

1. (1) Mount
2. (2) Bungee Strap

Parts Required (sold separately)

1. . (1) Fixture

Product Dimensions

Remove Mount Top

Twist and remove the mount top from the base.

Install Mount Top to Fixture

Pass the supply wires from the fixture through the mount top. Then thread the mount top onto the fixture and hand tighten until snug.

Replace Grommet – Optional

There are two grommets provided with fixture.

1. 2 holes grommet: It is assembled in the fixture, which is used for 2 supply cables entering into the base.
2. 1 hole grommet: It is included with fixture, which is used for 1 supply cable entering into the base.

Refer to the following steps to replace grommets.

1. Pull the 2 holes grommet out of the base.

2. Push the 1 hole grommet into the center hole.

Wire Connections

First, connect the wires from the fixture on the mount top. Use the following method.

Separate the end of the wire. Open one of the clips on a terminal block and insert one end of the wire. Close the clip and make sure the wire is secure. Use the same way to insert the other end of the wire into the opposite terminal block.

Last, insert the supply wire and any additional wires through the grommet on the base. Use the method above to finish connecting the rest of the wires.

Install Mount Base to Mount Top

Place the mount base onto the mount top and rotate until they lock.

Attach Fixture to Tree

Place the wire in the wire exit slot making sure it is facing down. Then attach the mount to your desired tree. Wrap the bungee straps around the tree until a proper hole fits the tree size. Remove the lock nut and place the bolt through the hole on the bungee strap. Secure using the lock nut. Hand tighten until snug.

Customer Support

Help Hotline: 1-813-978-3900
Mon-Fri 9am-6pm (EST)

Specifications and product details subject to change without notice.
© Copyright 2021, AMP® Lighting, Lutz FL USA 33549
All rights reserved.
customersupport@amplighting.com
Phone: 813.978.3900
Web:www.amplighting.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>