Anolis HP111 Ambiane Surface Mount Instruction Manual
- June 3, 2024
- ANOLiS
Table of Contents
Anolis HP111 Ambiane Surface Mount
INSTALLATION INSTRUCTIONS
AMBIANE HP111 SURFACE MOUNT
-
STEP 1
- CEILING OPENING
Standard mounting hole with diameter of 100-105mm.
- CEILING OPENING
-
STEP 2
- MOUNTING OF CONTROL UNIT
Place control unit above the ceiling through the ceiling opening.
Mount the control unit to ceiling via two mounting holes and suitable fasteners.
- MOUNTING OF CONTROL UNIT
-
STEP 3
- PRIMARY POWER CONNECTION
Install terminal block to power cable (from Ambiance Power Rack or Ambiance Power HP) and connect it to Primary power socket of the control unit.
- PRIMARY POWER CONNECTION
-
STEP 4
- DATA CABLES CONNECTION (DMX OR DALI)
DMX CONNECTION
- DATA CABLES CONNECTION (DMX OR DALI)
| 0V | D- | D+ |
|---|---|---|
| Data Ground | Data – | Data + |
Install terminal blocks on DMX or DALI data cables and conne-ct them to the
control unit.
Set the DIP switches to positions according to your operation mode. The fixture
can be controlled by DMX or DALI (switch 11 in OFF position). 
- STEP 5
- SECONDARY POWER CABLE CONNECTION 48V (PSU SCOPE OF OTHERS)
Install terminal block on Secondary power cable and connect it to Secondary power socket of the control unit.
- SECONDARY POWER CABLE CONNECTION 48V (PSU SCOPE OF OTHERS)
- STEP 6
- LED UNIT CONNECTION
- Shorten power/data cable of LED unit to required length.
- Strip these lengths of LED unit‘s cable for wiring connection.
LED Unit
Connection
| TERMINAL BLOCK | + | A | B | – |
|---|---|---|---|---|
| Color of Wire | Red | White | Blue | Black |
Install
terminal block on LED unit‘s cable and connect it to the control unit
.
Connected
luminaire before installation.
LED unit connected to control unit prior to mounting.
-
STEP 7
- MOUNTING OF LUMINAIRE
- Max. possible thickness of a ceiling material is 20 mm. Insert the fixture into the ceiling mounting hole. Spread the holders and tighten them up with Allen key as illustrated.
Tighten the holders on both sides until the fixture is firmly se-cured to the ceiling.
-
STEP 8
- INSTALLATION OF ACCESSORIES RING LOUVER FOR 20° REFLECTOR
Insert the Ring Louver into the Top frame.
- INSTALLATION OF ACCESSORIES RING LOUVER FOR 20° REFLECTOR
ROBE lighting s. r. o. |
Palackeho 416 |
757 01 Valasske Mezirici |
Czech Republic |
Tel.: +420 571 751 500 |
E-mail: info@anolis.eu |
www.anolislighting.com
VERSION 1.0 / 04_2022
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>