Anolis Eminere MC Remote LED Lighting Instructions

Anolis Eminere MC Remote LED Lighting

Product Information

Specifications

• Product Models: Eminere, Eminere MC, Eminere Remote, EminereRemote MC, Eminere Inground
• Version: 1.0
• Date: 12.12.2023

Product Usage Instructions

Loss of Calibration Values Repair Procedure
If you encounter a loss of calibration values specifically for white colors (channel CTC), follow the steps below to repair:

1. This procedure is for service purposes only and should be conducted by trained technicians.
2. Ensure the device is powered off before proceeding with the repair.
3. Access the calibration settings menu on the device.
4. Initiate the calibration process for white colors.
5. Follow the on-screen instructions to input the necessary values accurately.
6. Complete the calibration process and save the new values.
7. Power on the device and verify that the white colors are displaying correctly.

Repairing Procedure

Repairing procedure in case of loss of calibration values for white colours (channel CTC)

For service purposes only!

1. Switch the calibrated Eminere to DMX mode 3 (12 channels)

2. Send a DMX data packet in which data for CTC meets calibrated colour:

   • 1800K = 21 CTC
   • 2700K = 66 CTC
   • 3200K = 91 CTC
   • 4200K = 141 CTC
   • 5600K = 211 CTC
   • 6500K = 255 CTC
     We recommend to send also RGBW values and a Dimmer value to make sure the Eminere responds.

3. Read in the RDM Manager calibrated Eminere. There are 4 bytes of calibration values in the field “LED calibration 4 bytes HEX! (RGBW/RGBA)“ in the section “Manufacturer PIDs“. The calibration values are readed from the first processor (see the picture below).

4. Enter calibration values (factory values for each fixture) and save them to the Eminere by means of the green arrow (it can occur that both halves of the Eminere lights in different colours). If the colour beam from the Eminere has not changed, try to change some byte of calibration values and save it to the Eminere and again change the changed byte to the correct value and save it to the Eminere. If the colour beam from the Eminere still has not changed, you probably have set incorrect value of CTC in DMX data packet.
   If you do not have set correct CTC colour, values “FF FF FF FF” will appear in the field “LED calibration 4 bytes HEX! (RGBW/RGBA)“ and saving of calibration values to the Eminere will not be successful.

5. Go to step 2 , set another CTC colour and repeat steps 3 and 4.

FAQ (Frequently Asked Questions)

Q: Can I perform the calibration repair procedure myself?
A: No, the loss of calibration values repair procedure is intended for service purposes only and should be carried out by trained technicians to ensure proper calibration.

Q: What should I do if I experience issues with colors other than white?
A: If you encounter issues with colors other than white, refer to the user manual for troubleshooting steps or contact customer support for assistance.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>