WAMPLERPEDALS.COM

HOT WIREDv2

Brent Mason • Signature Distortion I Overdrive

The pedal that Nashville studio ken Brent Mason uses daily …

Tv2his is a pedal that has two independent overdrive/distortion circuits in one enclosure. Each has their own independent controls.

Volume: Controls the total output volume of the channel.

Tom This adjusts between a bossier sound at the fully counterclockwise position. to more treble sound when turned fully clockwise.

Gain: These controls adjust the total amount of overdrive/distortion of the channel. Turning the Gain control clockwise will increase the amount of gain in the circuit.

Overdrive Channel Blond: This control works to go from a totally clean signal at fully counter-clockwise to just the overdriven signal at fully clockwise.

Bass Boost Switches: Normal is the middle position and Is neutral. The Fat setting starts to add some low-mid punch. The Fatter setting adds in the most bass.

Power: This pedal was designed around the usage of a 9v or I8vDC power source and is intended to sound its best at 9V. To avoid damage to the pedal, do not exceed I8VDC. do not use center pin positive adapters and do not use AC power. Using an incorrect power adapter can load to damage and will void the warranty on the pedal. This pedal draws 17mA at 9vdc. The warranty begins at the point of purchase.

WAMPLER

Pedals Limited Warranty WAMPLER offers o five (5) year warranty to the original purchaser that this WAMPLER product will be free from defects in material and workmanship. A doted soles receipt will establish coverage under this warranty. This warranty does not cover service or parts to repair damage caused by accident, neglect, normal cosmetic wear, disaster, misuse, abuse, negligence, inadequate packing or shipping procedures and service, repair or modifications to the product, which have not been authorized or approved by WAMPLER. If this product is defective in materials or workmanship as warranted above, your sole remedy shall be repair or replacement as provided below.

RETURN PROCEDURES

In the unlikely event that a defect should occur, follow the procedure outlined below. Defective products must be shipped, together with a doted sales receipt, freight prepaid and insured directly to WAMPLER SERVICE DEPT -5300 Harbor Street, Commerce, CA 90040. A Return Authorization Number must be obtained from our Customer Service Department prior to shipping the product. Products must be shipped in their original packaging or its equivalent; in any case, the risk of loss or damage in transit is to be borne by the purchaser. The Return Authorization Number must appear in large print directly below the shipping address. Always include a brief description of the defect, along with your correct return address and telephone number.

When emailing to inquire about a returned product, always refer to the Return Authorization Number. If WAMPLER determines that the unit was defective in materials or workmanship at any time during the warranty period, WAMPLER has the option of repairing or replacing the product at no additional charge, except as set forth below. Al replaced parts become a property of WAMPLER. Products replaced or repaired under this warranty will be returned via ground shipping within the United States-freight prepaid. WAMPLER is not responsible for costs associated with expedited shipping, either to WAMPLER or the return of the product to the customer.

INCIDENTAL OR CONSEQUENTIAL DAMAGE In no event is WAMPLER liable for any incidental or consequential damages arising out of the use or inability to use of any WAMPLER product, even if WAMPLER or a WAMPLER dealer has been advised of the possibility of such damages, or any other claim by any other party. Some states do not allow the exclusion or limitation of consequential damages, so the above limitation and exclusion may not apply to you. This warranty gives you specific legal rights and you may also have other rights which may vary from state to state.

FOR YOUR PROTECTION

Please complete the online warranty registration within (10) ten days of the date of purchase so that we may contact you directly in the event a safety notification issued in accordance with the 1972 Consumer Product Safety Act.

This equipment has been tested and found to comply with the hits for a Closs B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on o circuit different from that to which      the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

CUSTOMER SUPPORT

Our dedicated staff is ready to help you with any warranty or product questions – please email us at help@viamplemedals.com or call us at 765-352-8626 Please remember to register your pedal as soon as possible after purchase at the following web page to ensure quicker service if you should ever need to make a warranty claim: www.RegisterYourWampler.com

For a more in depth manual visit: www.wamplerpedals.com/downloads/

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>