Aquascape 84059 4.5 Watt Color Changing Spotlight Installation Guide
- June 3, 2024
- Aquascape
Table of Contents
Aquascape 84059 4.5 Watt Color Changing Spotlight
Aquascape Color-Changing Lights are developed to provide impressive lighting options for ponds, waterfalls, and landscapes. This instruction manual will guide you through the proper installation of Aquascape colorchanging lighting as well as recommended maintenance procedures to ensure long-term effectiveness.
-
2-Watt Color-Changing Waterfall Light
Item #84057 -
4.5-Watt Color-Changing Spotlight
Item #84059 -
8-Watt Color-Changing Spotlight
Item #84060
PARTS INCLUDED
Required Products
NOTE : The lighting control hub is required to power and control Aquascape color-changing lights. Each hub can control up to 150-Watts of lights.
Recommended Products
Safety Information
WARNING : It is recommended whenever working in or near water to have all electrical devices plugged into a ground fault interrupter (GFCI) that has been installed by a licensed electrician
- To reduce the risk of electrical shock or damage to the light, all wiring and junction connections should be made per local codes. Requirements may vary depending on usage and location
- The power cable should be protected at all times to avoid punctures, cuts, bruises, and abrasion.
- Operating the light fixture outside of the 10.8-15 volt operating range voids the product warranty and may damage or shorten the life of the LEDs.
IMPORTANT : Aquascape, Inc. is not responsible for losses, injury, or death resulting from a failure to observe these safetyprecautions, misuse or abuse of pumps or equipment.
Model| 2-Watt Color-Changing Waterfall Light|
4.5-Watt Color-Changing Spotlight| 8-Watt Color-Changing
Spotlight
---|---|---|---
Dimensions| 2″ diameter x 1.25″H| 3″ diameter x 3″H| 3″ diameter x 3″H
Voltage Min-Max/Tensions Min-Max| 10.8V-15V| 10.8V-15V| 10.8V-15V
Wattage| 2±10%| 4.5±10%| 8±10%
Lumens| 52 lm (white)| 128 lm (white)| 223 lm (white)
Kelvin Temperature| 3,000 K (white)| 3,000 K (white)| 3,000 K (white)
Color Rendering Index| 70 (white)| 70 (white)| 70 (white)
Beam Angle Spread| 30°| 30°| 30°
Cord Length| 15′| 15′| 15′
Installation
MOUNTING OPTIONS
- Choose the option that works best for each light.
- Removable mounting stand (#84059 and #84060 only)
- Remove the threaded nut from the fixture holder and insert holder into the base. Use the threaded nut to secure the fixture holder (Ex. 1).
- Landscape stake (#84059 and #84060 only)
- Remove the threaded nut from the fixture holder and thread the stake clockwise into the bottom of the fixture holder (Ex. 2).
- No stand or stake
- The lights can be used without the fixture holder to allow the fixture to be disguised between rocks (Ex. 3).
- Adjusting the light angle
-
- To adjust the angle, push up or down on the fixture holder until it “clicks” into the desired position (Ex. 4).
- Waterfall and Up Light Base (#84057 only)
- The pre-installed stand can be removed for installation in tight spaces (Ex. 5).
CONNECT LIGHT FIXTURES
-
Aquascape color-changing lights include 5-pin, quick-connect fittings to provide tool-free electrical connections.
WARNING : Do not cut or remove the quick-connect fitting or isolation chamber, as it will damage the light and void the warranty (Ex. 6). -
Color-changing splitters and extension cables are available to install multiple lights. See the recommended products section for available extensions and splitters.
-
Connect lights to Aquascape color-changing splitters and extensions (Ex. 7).
NOTE : Quick-connect connections must be fully tightened to prevent water from entering. Dielectric grease, available at most home improvement stores, can be used in all connections to further prevent water infiltration. -
For installations with existing low-voltage lighting or components, split the power after the transformer, before the color-changing lighting control hub, to run color-changing light off the existing transformer (Ex. 8).
WARNING : Do not submerge quick-connect fittings, as moisture entering the connections will damage the lights.
SMART CONTROL HUB INSTRUCTIONS
-
The Aquascape Smart Control Hub is required to power and control Aquascape color-changing lights.
-
Connect the light, splitter, or extension to the 5-pin quick- connect fitting attached to the hub (Ex. 9).
NOTE : Each Smart Control Hub can control up to 150-watts of color- changing lights.
NOTE : Multiple Smart Control Hubs can be used to assign Ex. 9 multiple colors simultaneously.
NOTE : The Smart Control Hub is weather resistant, but not waterproof. Install it off the ground and protected from the elements. -
Aquascape color-changing lights are designed to operate on a 12-volt, outdoor-rated transformer (not included).
NOTE : It is recommended to locate the transformer as close to the light fixtures as possible to avoid voltage drops caused by long cable runs. -
Plug the transformer into a GFCI-protected outlet.
PAIRING PROCEDURE
-
Plug the Smart Control Hub into a 12-Volt transformer, and the unit will automatically enter pairing mode.
NOTE : The blinking blue light on the face of the unit indicates the hub is in pairing mode and ready to be connected. -
Download the Aquascape Smart Control App (available on iOS or Android App Store).
-
Open the Aquascape Smart Control App and click ‘Create New Account’ (Ex. 10).
NOTE : If you already have an account, login with your username and password. -
Once logged in, click the three dashes in the upper, right-hand corner of the home screen (Ex. 11).
-
Click ‘Add New Device’ (Ex. 12).
NOTE : Adequate Wi-Fi coverage is required (2.4 GHz networks supported). -
Continue to follow on screen instructions to complete the pairing process.
-
To reset the device to factory defaults, press and hold the pairing button for ten seconds and release when the light begins rapidly flashing (Ex. 13).
General Maintenance
Periodically clean the fixture with fresh water, removing any existing algae, debris, or buildup.
Troubleshooting
- Lights won’t turn on
- Make sure the outlet is receiving power
- Make sure the ground-fault circuit interrupter (GFCI) is not tripped
- Check to verify that the lights are receiving the correct voltage
- Verify the Smart Control Hub is properly paired, re-pair the device
- Lights won’t turn off
- Verify the Smart Control Hub is properly paired, re-pair the device
- Device won’t pair
- Make sure the outlet is receiving power
- Make sure the network name and password are typed in correctly
- Make sure you have adequate wireless coverage to connect the device
- Reset the device to factory defaults
- Make sure the ground-fault circuit interrupter (GFCI) is not tripped
Replacement Parts
| No. | Item number/description |
|---|---|
| 1. | 84037 – Waterfall Light Replacement Base |
| 2. | 84036 – 4.5/8-Watt LED Color-Changing Spotlight Replacement Mounting Kit |
| 3. | 84073 – Color-Changing Light Remote |
Warranty Information
5 YEAR WARRANTY
Aquascape warrants that the Color-Changing Light will be free of manufacturing
defects for five years after date of purchase. Proof of purchase required.
Warranty does not cover damage resulting from electrical supply problems,
improper wiring, lightning, negligent handling, misuse, or lack of reasonable
maintenance or care. This product should only be operated in fresh water
without corrosive chemicals like chlorine or bromine. If upon Aquascape’s
inspection, the light shows evidence of a manufacturing defect, Aquascape’s
liability is limited, at Aquascape’s option, to the repair of the defect, or
the replacement of the defective product or refund of the original purchase
price. The warranty excludes costs of labor, removal of product, shipping and
expenses related to the installation and re-installation of the product. No
liability for loss or damage of any nature or kind, whether arising out of or
from the use of the product, whether defective or not defective, is assumed by
Aquascape, Inc. or its affiliates. Aquascape shall not be liable for any
incidental, consequential or other damages arising under any theory of law
whatsoever.
For more information about our company or products, please visit our website
at aquascapeinc.com or call us at US
866-877-6637 CAN
866-766-3426
©2021 Aquascape, Inc. All Worldwide Rights Reserved
- aquascapeinc.com
- ☎ CAN 866-766-3426
- ☎ US 866-877-6637
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>