Aquascape 84031 Pond Landscape LED Light Instruction Manual

INSTALLATION INSTRUCTIONS
POND AND LANDSCAPE LED LIGHTS

84031 Pond Landscape LED Light

Aquascape Pond and Landscape LED Lights are developed to provide impressive lighting options for ponds, waterfalls, and landscapes. This instruction manual will guide you through the proper installation of Aquascape Pond and Landscape LED Lights as well as recommended maintenance procedures to ensure long-term effectiveness.
1-Watt Spotlight
Item #84031
1-Watt Waterfall Light
Item #84032
3-Watt Spotlight
Item #84033
6-Watt Spotlight
Item #84034

☎ Contact Us
For more information about our company or products, please visit our website at aquascapeinc.com or call US 866-877-6637 CAN 866-766-3426.
Contents – #84032

Contents – #84031, #84033, and #84034

Required Products

Recommended Products

Extension Cable (#84023)
Quick-Connect Photocell with Timer (#84039)

Safety Information

WARNING: It is recommended whenever working in or near water to have all electrical devices plugged into a ground fault interrupter (GFCI) that has been installed by a licensed electrician.

• To reduce the risk of electrical shock or damage to the light, all wiring and junction connections should be made per local codes. Requirements may vary depending on usage and location.
• The power cable should be protected at all times to avoid punctures, cuts, bruises, and abrasion.
• Operating the light fixture outside of the 9-15 volt operating range voids the product warranty and may damage or shorten the life of the LEDs.

IMPORTANT: Aquascape, Inc. is not responsible for losses, injury, or death resulting from a failure to observe these safety precautions, misuse or abuse of pumps or equipment.
Find us on:

| facebook.com/aquascapeinc
youtube.com/aquascape4
pinterest.com/aquascapeinc
---|---

Pond and Landscape LED Lighting Specs

Model| 1-Watt Waterfall Light| 1-Watt Spotlight| 3-Watt Spotlight| 6-Watt Spotlight
---|---|---|---|---
Dimensions| 2″ diameter x 1.25″H| 1.5″ diameter x 2″H| 3″ diameter x 3″H| 3″ diameter x 3″H
Material| Die-Cast Metal| Die-Cast Metal| Die-Cast Metal| Die-Cast Metal
Voltage Min-Max| 9V-15V| 9V-15V| 9V-15V| 9V-15V
Wattage| 1.2±10%| 1.2±10%| 3±10%| 5.8±10%
Lumens| 45 lm| 45 lm| 150 lm| 340 lm
Kelvin Temperature| 3,000 K| 3,000 K| 3,000 K| 3,000 K
Color Rendering Index| 75| 75| 75| 75
Beam Angle Spread| 30°| 30°| 30°| 30°
Cord Length| 14.5′| 14.5′| 14.5′| 14.5′

Installation

MOUNTING OPTIONS

• Choose the option that works best for each light.
  – Removable mounting stand (#84031, #84033, and #84034 only)
  ■ Remove the threaded nut from the fixture holder and insert holder into the base. Use the threaded nut to secure the fixture holder (Ex. 1).
  – Landscape stake (#84031, #84033, and #84034 only)
  ■ Remove the threaded nut from the fixture holder and thread the stake clockwise into the bottom of the fixture holder (Ex. 2). – No stand or stake
  ■ The lights can be used without the fixture holder to allow the fixture to be disguised between rocks (Ex. 3). – Adjusting the light angle
  ■ To adjust the angle, push up or down on the fixture holder until it “clicks” into the desired position (Ex. 4). – Waterfall Light Base (#84032 only)
  ■ The pre-installed stand can be removed for installation in tight spaces (Ex. 5).

CONNECT LIGHT FIXTURES

• Aquascape pond and landscape lights include 2-pin, quick-connect fittings to provide tool-free electrical connections.
  WARNING: Do not cut or remove the isolation chamber, as it will damage the light and void the warranty (Ex. 6).

• Splitters and extension cables are available to install multiple lights.
  See the recommended products section for available extensions and splitters.

• Connect lights to quick-connect splitters and extensions (Ex. 7). NOTE: Quick-connect connections must be fully tightened to prevent water from entering. Dielectric grease, available at most home improvement stores, can be used in all connections to further prevent water infiltration.

• If desired, the Aquascape Quick-Connect Photocell with Timer can be installed at this time. See the recommended products section for more information).

WARNING: Do not submerge quick-connect fittings, as moisture entering the connections will damage the lights.
NOTE: The light can also be wired directly in pre-existing low-voltage lighting systems. Cut off the quick-connect and use a UL listed connector rated for outdoor use.
NOTE: Light failure as a result of improper wiring is not covered under warranty.

TRANSFORMER SETUP

• Aquascape pond and landscape lights are designed to operate on a 12-volt, outdoor-rated transformer.
  WARNING: Aquascape pond and landscape lights have a max voltage operating range between 9 and 15 volts. Operating the light outside of this voltage range voids the product warranty and may damage or shorten the life of the light.
  NOTE: It is recommended to locate the transformer as close to the light fixtures as possible to avoid voltage drops caused by long cable runs.
  NOTE: It is recommended to bury low voltage cables 6″ or less.

• Connect the light, photocell, splitter, or extension cable to the transformer (Ex. 8).

• Plug the transformer into a GFCI-protected outlet (Ex. 9).

General Maintenance

• Periodically clean the fixture with fresh water, removing any existing algae, debris, or buildup.

Troubleshooting

• Lights are dim or won’t turn on
  – Check for loose connections
  – Make sure the outlet is receiving power
  – Make sure the ground-fault circuit interrupter (GFCI) is not tripped
  – Check to verify that the lights are receiving the correct voltage
  – Verify that the photocell is functioning properly
  – Verify proper transformer loading
  – Verify that long cable runs are not causing voltage drop

• Lights won’t turn off
  – Verify that the photocell (not included) is functioning properly

Replacement Parts

Pond and Landscape LED Lighting Replacement Parts

Warranty Information

5 YEAR WARRANTY
Aquascape warrants that the lights will be free of manufacturing defects for five years after date of purchase. Proof of purchase required. Warranty does not cover damage resulting from electrical supply problems, improper wiring, splices made with without UL listed connections rated for outdoor use, lightning, negligent handling, misuse, or lack of reasonable maintenance or care. This product should only be operated in fresh water without corrosive chemicals like chlorine or bromine. If upon Aquascape’s inspection, the lights shows evidence of a manufacturing defect, Aquascape’s liability is limited, at Aquascape’s option, to the repair of the defect, or the replacement of the defective product or refund of the original purchase price. The warranty excludes costs of labor, removal of product, shipping and expenses related to the installation and re-installation of the product. No liability for loss or damage of any nature or kind, whether arising out of or from the use of the product, whether defective or not defective, is assumed by Aquascape, Inc. or its affiliates. Aquascape shall not be liable for any incidental, consequential or other damages arising under any theory of law whatsoever.

For more information about our company or products, please visit our website at aquascapeinc.com
or call us at US 866-877-6637 CAN 866-766-3426
©2023 Aquascape, Inc. • All Worldwide Rights Reserved
☎ US 866-877-6637
☎ CAN 866-766-3426
aquascapeinc.com

References

• Water Features, Outdoor Fountains, Pond Pumps by Aquascape

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>