goobay 60471 Wireless Fast Charger Instruction Manual

goobay 60471 Wireless Fast Charger Instruction Manual

Specifications

9.0 V , 1.12 A, 10.0 W; 9.0 V , 1.66 A, 15.0 W

Frequency band| 110.0-205.0 kHz
Wireless charging distance| max. 6 mm
Minimum distance to medical devices| 20 cm
Material| silicone
Dimensions | Weight| 184 x 99 x 25.5 mm | 180 g
Standby power consumption| ≤ 0.6 W
Protection class| III
Protection against| overload, over-voltage, high temperatures, debris
Operating conditions| 0 ~ +40°C | 10-85 % RH
Storage conditions| -25 ~ +65°C | 10-85 % RH
Charging cable

Connections| USB-C™ plug, USB-A 2.0 plug
Cable length | Weight| 1 m | 32 g

Symbols used

For indoor use only| IEC 60417- 5957|
---|---|---
Direct current| IEC 60417- 5031|
Class III equipment| IEC 60417- 5180|
Recycling| ISO 7001 – PI PF 066|

Safety instructions

The user manual is part of the product and contains important information for correct use.

Read the user manual completely and carefully before use.

The user manual must be available for uncertainties and passing the product.

• Keep this user manual.
• Do not open the housing.
• Do not modify product and accessories.
• Do not short-circuit connectors and circuits.

A defective device may not be put into operation, but must be protected against further use.

• Use product, product parts and accessories only in perfect condition.
• Avoid stresses such as heat and cold, moisture and direct sunlight, microwaves, vibrations and mechanical pressure.
• In case of questions, defects, mechanical damage, trouble and other problems, non-recoverable by the documentation, contact your dealer or producer.

Not meant for children. The product is not a toy!

Secure packaging, small parts and insulation against accidental use.

Dangers in the vehicle
Attention while driving may be impaired and serious accidents, personal injury and property damage may occur.

• Place the product so that the driver is not obstructed.
• Do not operate your charging equipment while driving.

There is a risk that the charging device may fall or become a skidding hazard.

• Do not pick up your charging devices while driving if they fall off the charging mat.
• Do not charge devices that are larger or thicker than the surface of the charging mat.
• Only use the charging mat when the engine is running.

Otherwise, there is a risk that the capacity of the vehicle battery will be reduced to such an extent that it will no longer be possible to start the engine.

Heat storage
Heat is generated during inductive charging.

Make sure that there are no metal parts on the back of your device (e.g. metal cover, metal plate for magnetic holder).

Metal heats up strongly in the induction field and can cause damage to the product or your end device.

Do not cover the product.

Magnetism
The product contains magnetic materials.

• Consult a doctor before use to ensure compatibility with implanted medical devices.
• Keep a minimum distance of 20 cm from medical devices.
• Do not store and/or operate the product near bank cards.

Tripping hazard

Install the product so that no persons or property can be injured or damaged, e.g. by falling, tripping or the like.

Description and function

Product

The product is an inductive charging mat including charging cable for wireless charging of smartphones and other devices supporting the Qi standard with up to 15 W of power. It is suitable for use in vehicles and supports Quick Charge technology (Charging adapter not included in the scope of delivery).

Scope of delivery

Wireless Quick-Charging Pad 15 W, Charging cable, User Manual

Operating Elements

1. Non-slip surface
2. Charging interface
3. Smartphone holder
4. USB-C™ socket
5. USB-A plug
6. USB-C™ plug

Intended use

We do not permit using the device in other ways like described in chapter „Description and Function“ or in the „Safety Instructions“.
Use the product only in dry interior rooms. Not attending to these regulations and safety instructions might cause fatal accidents, injuries, and damages to persons and property.

Preparation

1. Check the scope of delivery for completeness and integrity.
2. Compare the specifications of all used devices and ensure compatibility.

Connection and operation

1. Place the charging mat on a dust-free, level, horizontal surface.

2. Connect the USB-C™ socket of the charging mat to a USB power source via the charging cable.
   This can be either a 230 V USB charging adapter, a 12/24 V car USB charger or the USB socket of a PC (see Fig. 2).
   
   The USB power source must support at least 5 V / 2 A. To use the fast charging mode (15 W), a Quick Charge power adapter with 9 V / 2 A or 12 V / 2 A must be used.

3. Place a Qi standard compatible device on the charging mat (see Fig. 3).
   
   Charging your device is also possible with a protective cover, provided the cover does not contain any metal parts and is not thicker than 6 mm.

4. Remove your device from the charging mat when it is fully charged.

5. Disconnect all cable connections after use.

Smartphone holder

In addition to the charging function, the charging mat also has a convenient smartphone holder for using your device in navigation mode (see Fig. 4).Simultaneous wireless charging of your device is not possible, as the device is then no longer within the charging induction radius.

Maintenance, Care, Storage and Transportation

The product is maintenance-free.

NOTICE! Material damage

• Only use a dry and soft cloth for cleaning.
• Do not use detergents or chemicals.
• Store the product out the reach of children and in a dry and dust-protected ambience when not in use.
• Store cool and dry.
• Keep and use the original packaging for transport.

Disposal instructions

Product

According to the European WEEE directive, electrical and electronic equipment must not be disposed with consumers waste. Its components must be recycled or disposed apart from each other. Otherwise contaminative and hazardous substances can damage the health and pollute the environment.
As a consumer, you are committed by law to dispose electrical and electronic devices to the producer, the dealer, or public collecting points at the end of the devices lifetime for free. Particulars are regulated in national right. The symbol on the product, in the user manual, or at the packaging alludes to these terms. With this kind of waste separation, application, and waste disposal of used devices you achieve an important share to environmental protection. WEEE No: 82898622

Packaging
Packaging can be disposed of free of charge at the suitable collection points – paper belongs in paper bins, plastics belong in yellow sacks and glass belongs in used glass bins.
DE4535302615620

EU Declaration of conformity

Hereby Goobay®, a registered trademark of Wentronic GmbH, ensures that the mentioned radio system type is conformed to Directive 2014/53/EU. The full text of EU Declaration of Conformity is available at the following Internet address:
https://www.wentronic.com/en/

References

• Wentronic
• Electronic accessories wholesaler with top brands | Wentronic
• Grossiste en accessoires électroniques avec les meilleures marques | Wentronic
• Grossista di accessori elettronici con i marchi più importanti | Wentronic
• Hurtownia akcesoriów elektronicznych z najlepszymi markami | Wentronic

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>