BORMANN BDS3000 Small Safe Instruction Manual

BORMANN BDS3000 Small Safe

Operating instructions

Caution: never keep the keys in the safe. We recommend that you separate both keys and store in two safe locations.

Opening the safe

To open the safe for the first time, remove the small plastic cover (B – diagram 1) on the front panel, insert the key into the keyhole and turn it counterclockwise at the same time, turn the doorknob ( “A” – diagram 1) clockwise to open the safe.

Technical Data

• Dimensions 31x20x20cm
• Battery type: 4 x ΑΑ (1,5V)

Installing the batteries

The safe requires 4 x AA (1.5V) batteries. Open the safe, push the battery cover plate (D – diagram 2) on the back of the door and install the batteries.
Make sure that the batteries are fitted with the correct corresponding polarity. Use of alkaline batteries is recommend.

Programming the code

• A. With the safe door open, press the red button (c – diagram 2) on the back of the door near the hinge, release it and you will hear two beeps. The yellow
  light will be on at the same time.

• B. Now press from 3 to 8 numbers that you wish to use as a combination, and confirm by pressing the letter “A” or” B” within 15 seconds. The safe bleeps twice and the yellow light will go off, your personal code is now set.

• C. Write down your new combination immediately and check whether your new use of alkaline batteries is recommended.

Using your safe

Combination has been programmed or not on conditions of the safe door open.
To open the safe, enter your personal code followed by the letter “A” or ‘LB” you will hear a beep and the green light will be on, then turn the doorknob in clockwise direction to open the door within 5 seconds.
If you or an intruder uses the incorrect group of numbers, it will not open. If the incorrect combination is used 3 times consecutively, you must wait for 20 seconds before reattempting.
If again the incorrect combination is selected 3 times, you must wait approximately 5 minutes before reattempting access.

Battery replacement warning

If the batteries are low, the red light (in the middle of the number panel) will warn you immediately. To test the batteries, just input your personal numbers to open the door. If the batteries are low, the red light will be on. If nothing happens, it means that the batteries are in order.

Replacing the batteries

The safe requires 4 x size “AA” (1.5V) batteries.
Open the safe, push the battery cover plate “D” (see diagram 2) on the back of the door and replace the 4 PCS old batteries. You must reprogram the code, using the above third step.
Use of alkaline batteries is recommended.

Override instruction to open the safe

For your convenience, we have engineered a manual override system for your safe. If you forget or misplace your combination, remove the small central plate on the front panel ( B – diagram 1) , insert the key into the keyhole and turn it in a counter-clockwise direction, then turn the knob (A – diagram

1. in a clockwise direction towards the right. This will manually open your safe at any time.

Installing the safe

To reduce the risk of theft of the safe , it can be secured to floor, wall or in a cupboard. For your convenience, there are holes (diameter 8mm) on the back and in the bottom; therefore it can be fixed by the expansion bolts.
CAUTION: The safe should be placed vertically when installing the safe.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>