EUROtops SC897 Column Bathroom Scale Instruction Manual

EUROtops SC897 Column Bathroom Scale

PLEASE READ THE INSTRUCTIONS MANUAL BEFORE YOUR FIRST USE. KEEP IT.

FEATURES

• Capacity : 6kg-180kg
• Precision (division) : 100g
• Low battery and overload indication
• Selection of unit weight: kg/lb/st:lb

DESCRIPTION OF PARTS

The lower and upper stand pole are identical.

BATTERY INSTALLATION

Batteries required: 4 x 1.5V AAA (not included) Before assembling the scale, please insert the batteries at the back of the platform.

MOUNTING

2 persons may be required for the mounting.
Firstly, unpack and put all the scale parts, listed in section: “Description of parts”, on the floor and proceed as below:

1. Insert the wire of the stand base (1) into the lower pole (2). When inserting the wire, ensure the connector of the wire comes out completely of the lower pole.
   IMPORTANT : Before insertion, make sure that the end of the pole (2) with the 2 holes for the screws is directed downwards (towards the stand base). The hole of the single screw, at the other end of the pole, should be facing the back of the scale.

2. Insert the 2 screws at the bottom of the pole (6) and fasten them.

3. Fully Insert the wire, which comes out of the lower pole, into the pole connector (3), then connect the pole connector to lower pole. Insert the screw and fasten it.
   IMPORTANT : The two screw holes of the connector should face the back of the scale.

4. Then, fully insert the wire of the LCD display (5) into the upper pole.
   IMPORTANT : Before insertion of the wire, make sure that the end of the pole with the 2 holes for the screws is directed upwards (towards the LCD display). The hole of the single screw, at the other end of the pole, should be facing the back of the LCD display.

5. After full insertion, connect the upper pole (4) with the LCD display (5). Insert the screw (7) and fasten it.

6. Connect the wire connectors of lower and upper poles together (10). Note: While doing this operation, one person should firmly hold the upper pole and the other one should do the connection.

7. Gently push the long part of the connected wire into the upper rod. For easy insertion, gently push inside with your help of your finger Note: While doing this operation, one person should firmly hold the upper pole. ATTENTION: Make sure not to disconnect the thin colored wires.

8. Connect the upper pole (4) with connector (3), which is already connected with the lower pole. Insert the screw (9) and tighten it.

Note : If you intend to disassemble the scale, please do it horizontally on the floor to avoid the parts to fall down and to damage the wire and connectors.

OPERATION

1. Setting weight unit
   Press repeatedly the SET switch, at the back of the LCD display, to select the weight unit (kg/lb/st). Stop pressing when you reach the desired unit.

2. Weighing

3. Before using, make sure to place the scale on the hard and flat surface.

4. Step on the scale platform gently. Position your feet evenly near the center. Stand still and erect.
   Note : the scale stand pole can be tilted forward up to 15°.

5. Keep your body still and erect until the scale stabilizes your weight. Your weight will flash twice and be displayed for about 10 seconds. Then the scale turns off automatically if you don’t use it within about these 10 seconds.

TROUBLE SHOOTING

• Please change the batteries with new ones when « LO » displays. « LO » means that the battery power is low.
• « Err » indicates that there is an overload.

WARNINGS

• Keep away from sources of heat, direct sunlight, humidity, water or other liquids.
• Do not immerse in water.
• Do not subject it to strong impacts and do not throw it.
• Do not drop, short-circuit, modify, disassemble or puncture it.
• It is not a toy. Keep out of reach of children.
• Remove the batteries if you plan not to use the device during a long period.
• Do not try to repair the device. All the repairs must be made by a qualified technician.
• The glass platform may be pretty slippery when wet, thus make sure both the glass and your feet are dry before use. Avoid wearing your socks before weighing to avoid sliding.
• Never jump or stomp on the scale.

BATTERY WARNINGS

• Please remove the batteries if you plan not to use the device for a long period.
• Never mix alkaline, regular (carbon-zinc) and rechargeable (nickel hydride) batteries.
• Never mix old and new batteries.
• Never try to charge non-rechargeable batteries.
• Remove rechargeable batteries from the appliance (if possible) before charging.
• Rechargeable batteries should always be charged under the supervision of an adult.
• Remove used batteries.
• Never short-circuit the power terminals.
• Always use batteries of the recommended type or equivalent type.
• Observe the correct polarity when replacing the batteries.
• Batteries must not be disposed of with household waste but must be returned to battery collection points.
• Do not dismantle batteries.

CLEANING AND MAINTENANCE

• DO NOT IMMERSE IN WATER OR ANY OTHER LIQUID. DO NOT PLACE IT UNDER A RUNNING TAP.
• DO NOT USE ABRASIVES OR SOLVENTS.
• Clean with a dry and lint-free cloth. If it is dirty, use a slightly damp cloth and dry thoroughly.
• You can use a soft tissue with alcohol or glass cleaner to clean the glass platform. No soap or other chemicals.
• It is important that no liquid reaches the inside of the unit.
• Store the device in low temperatures, dry and ventilated place.
  WARNING : You should not dispose of this device with your household waste. A selective collection system for this type of product is implemented by your local authorities. Please contact your local authorities to find out how and where collection takes place. These restrictions apply because electrical and electronic devices contain dangerous substances that have harmful effects on the environment or on human health and must be recycled. This symbol indicates that electrical and electronic devices are collected selectively. The symbol shows a waste container crossed out with an X symbol. Imported by EML – trading name Prodis, 1 rue de Rome 93110 Rosny-sous-Bois- France/ Made in PRC Marketed by EUROTOPS VERSAND GMBH D-40764 LANGENFELD, Germany.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>