SKYWIN iTalk PRO Conference Speaker with Microphone User Guide
- August 16, 2024
- SKYWIN
Table of Contents
**SKYWIN iTalk PRO Conference Speaker with Microphone User Guide
**
Specifications:
- Bluetooth version: V5.0
- USB version: USB 2.0 Plug and Play
- Charging: 2 Hours by 5V/1A by USB-C
- Battery: 2000mAH@3.7V
- Work Time: 8 Hours phone call/conference, 5 Hours music play
- Speaker: 2x3W
- Microphone Sensitivity: -36dB
- Microphone Pickup Range: 5 meters
- Speaker Frequency Range: 120Hz-20KHz
Questions?
Please contact us by email: christina@golds-in.com. 7/24, 365days work for you
iTalk PRO Quick Start Guide
Charging
Before start to use, please full charge the unit. Use Type–C cable to charge it. Charge current 5V/1A, charge time 2 hours.
Connect to Bluetooth
Turn On/Off the unit:
Press 2 seconds to turn on the unit, the unit will search last connected equipment to connect. After use, press 4 seconds turn off the unit.
Pairing:
When the unit is on, Press the Bluetooth button once to enter pairing mode, the and light red/blue flash, turn your mobile or laptop Bluetooth on and find “iTalk PRO” to connect. At any time, press the Bluetooth button once , it will enter pairing mode, you can use it to pair new device or 2nd device.
Make a call/Conference:
Use your mobile to dial or laptop to make a call /conference, use “+” “- “button to up/down the volume. Use button to mute the microphone. Use in the center to answer and end telephone calls by mobile (only for telephone calls, not activated for other apps like TEAMS, Skype, Wechat etc.).
Play Music:
Use buttons to control music play.
Connect to USB
Turn On/Off the unit:
Using attached USB-C cable to connect to laptop, Press 2 seconds to turn on the unit, Select the audio device “iTalk PRO” from laptop. After use, press 4 seconds turn off the unit.
Make a call/Conference:
Use your laptop to make a call/conference, use “+” “ – button to up/down the volume. Use button to mute the microphone (If you are using TEAMS professional version, the team can see your status). Use in the center to answer and end conference (only for TEAMS professional version, the team can see your status, not activated for other apps).
Keypad Layout
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>