GARDENA 19108-20 Smart Irrigation Control Set Instruction Manual
- June 5, 2024
- Gardena
Table of Contents
GARDENA 19108-20 Smart Irrigation Control Set
introduction
Congratulations!
You have chosen a top-quality product.
If you have any questions about installing or using your product, please
contact GARDENA Support on
www.gardena.de/service
Included in delivery
- 1 x smart Gateway
- 1 x power supply unit
- 1 x LAN cable
Getting started
The Gateway has two options for connecting to the Internet; using the LAN
cable or via Wi-Fi.
Connecting via cable (recommended):
- Download the free GARDENA smart system app from the Apple App Store or the Google Play Store.
- To connect via cable, follow the instructions in the app.
Connecting via Wi-Fi
You need your Gateway ID to connect via Wi-Fi; this can be found on the sticker on the underside of the Gateway.
-
Navigate to the Wi-Fi settings on your smartphone or computer. You should see the Gateway as an available Wi-Fi network here.
The name of the Gateway network is made up of GARDENA_config and the first four characters of the Gateway ID.
For example: GARDENA_config(9eb7). -
Connect to the Wi-Fi network. Use the last eight digits of your Gateway ID as the administrator password here.
-
Once you have connected successfully, the Internet LED lights up yellow continuously.
-
Use your preferred Internet browser to open the URL http://10.0.0.1
-
You are now in the Gateway admin interface.
Log in using the first eight digits of your Gateway ID as the password. -
You are now in the configuration menu in the Gateway admin interface. Open the Wi-Fi tab, go to the AVAILABLE NETWORK menu, select your home network and enter the password
for your network. Save your settings.
-
The Gateway will now start a software update, which can take several minutes.
When the Internet LED and the power LED light up green continuously, the Gateway has been successfully updated.
While you wait, download the free GARDENA smart system app from the Apple App Store or the Google Play Store. -
You can now link the Gateway to the GARDENA smart system app by following the instructions in the app.
Reset
You may need to use the reset function if you want to link your Gateway to a new Wi-Fi network for example, or if you have changed your Internet provider.
- Press and hold the reset button.
- At the same time, plug in the Gateway.
Hold down the reset button until the power LED lights up green.
The power LED will light up continuously for approx. ten seconds, before it starts to flash. The flashing can last for approx. one minute. When the power LED lights up continuously again, your Gateway is ready to connect to the Internet.