tala BRAS-PAP-01-US Plug-In Pendant Installation Guide
- June 3, 2024
- TALA
Table of Contents
tala BRAS-PAP-01-US Plug-In Pendant
PLUG-IN PENDANT
Thoughtful lighting, responsibly designed in London. Thank you for making the switch to Tala. Discover the full Tala family at us.tala.co.uk
BEFORE STARTING
Please read instructions thoroughly before installation and keep them for future reference. Please take extreme care when dealing with electrical equipment.
IMPORTANT
Bulb must be installed in fixture before turning on.
WARNING
Ensure power is turned OFF before inserting plug. Incorrect assembly may
result in risk of fire or electric shock.
CARE AND CLEANING
We recommend cleaning with a soft dry cloth. Do not use abrasive materials as these will damage the finish of the product.
WARRANTY AND AFTER-CARE
This product has a two-year warranty. If there appears to be a functional defect with the product during this time, please contact our team at customerservice@tala.co.uk.Please note, the flexible cable attached to this luminaire cannot be replaced; if the cable is damaged, recycle the luminaire and seek a replacement.
Plug-in Pendant – Provided Components
- x1 Cord with Dimmer Dial and US plug
- x1 Pre-assembled Tala Pendant Oak, Walnut, Brass or Graphite
- x2 Insulation tubes Adjustable – position in-line with nodes
- x2 Ceiling Nodes Consisting of 2 x caps and 2 x bases
- x1 Fixing Pack (Only use if suitable for ceiling type)
STEP 1
Decide on your layout for the Plug-in pendant, some examples are shown below.
Ensure you have enough cable for your desired layout before setting up the
pendant, and the dimmer is always accessible.
STEP 2
Attach Node base to ceiling. Always choose screws and plugs that are
appropriate for the ceiling material. Ensure the Node channel runs parallel
with the planned cord direction.
STEP 3
Position the Cord into the Node base at the desired points for your layout.
Slide the Insulation Tubes into the centre of the Ceiling Nodes. Screw the
Node cap onto the Node base clockwise until secure. Do not over-tighten
.
STEP 4
Insert your bulb into the pendant, rotating clockwise until tight. Take care
not to tighten too much to avoid breakage.
STEP 5
Insert the lamp plug into your chosen wall socket, making sure the power is
switched off.
STEP 6
Switch the power on and rotate the dial on your dimmer until the bulb lights
up. Adjust the dimmer for your desired light output.
Join the Community
- hello@tala.co.uk
- Instagram:@tala
- Facebook:talaHQ
- Pinterest:TalaLED
- Tag: lighttoliveby
Tala Energy Ltd. 25B Vyner Street, London, E2 9DG Tala North America, Inc. 2 Research Place, Suite 300, Rockville, MD 20850
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>