tala BSALT-I-SET-TRI-PD-01-EU Basalt Triple Pendant Installation Guide

: June 3, 2024
: TALA

Table of Contents

tala BSALT-I-SET-TRI-PD-01-EU Basalt Triple Pendant
BEFORE STARTING
TRIPLE COMPONENTS
PENDANTS DISPLAY GUIDE
CARE AND CLEANING
WARRANTY AND AFTER-CARE
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

tala BSALT-I-SET-TRI-PD-01-EU Basalt Triple Pendant

Thoughtful lighting, responsibly designed in London. Thank you for making the switch to Tala.
Discover the full Tala family at tala.co.uk

BEFORE STARTING

We advise the fitting of our ceiling rose and pendant to be performed by a qualified electrician. Please read through these instructions before commencing work, and keep them for future reference. Please take extreme care when carrying out these instructions.

IMPORTANT

This light fitting must be connected to the supply earth. If your lighting circuit does not have an earth, ask a qualified electrician to provide an earth facility. This light fitting is suitable for indoor use only. This fitting operates on 240V mains voltage. Please visit our website to see our recommended dimmers.

WARNING

Always switch off electricity supply at the mains during installation and maintenance. We recommend that the fuse is withdrawn or the circuit breaker is switched off whilst work is in progress. Do not just turn off at the wall switch. All fittings must be installed in accordance with current Building Regulations and IEE Wiring Regulations.

RECOMMENDED EQUIPMENT

Small flat head screwdriver
Wire strippers
Insulation tape
M10 (17mm) (5/8IN) spanner or Adjustable spanner Further equipment may be required for fixing to your ceiling.

TRIPLE COMPONENTS

STEP 1
Attach to the ceiling using screws and plug. Always choose screws and plugs that are appropriate for the ceiling.
STEP 2
Thread all three pendant cables though ceiling plate cord grips
STEP 3
Pull cables through to your desired length. Using a flat head screwdriver, tighten set screws B to secure them.
STEP 4
Cut off excess cable and strip wires to expose the copper core. Maintain all double insulation.
STEP 5
Connect the pendants, plate and mains wiring as shown.
STEP 6
Move up onto . Use toother washer and nut to secure it in place.
Do a final tighten with the correct spanner
STEP 7
Lift metal sleave and screw in the bulb firmly. Take care not to let the metal sleeve fall onto the bulb
STEP 8
Rotate metal steeve To align with the bulb
Carefully lower metal sleeve onto the bulb. you can now make and final tweeks to the alignment of the bulb and sleeve.

PENDANTS DISPLAY GUIDE

MINIMUM CORD LENGTH
For all bulbs shortest recommended cord length is 350mm

DISTANCE BETWEEN PENDANTS
Recommended minimum distance between pendant is 100mm

PENDANTS – RECOMMENDED CABLE LENGTHS

SCENARIO 1 Above a coffee or dining table, or where height is required for seated tasks
SCENARIO 2 Above side tables, or where height is required for storage
SCENARIO 3 Above a kitchen island or bar, or where height is required for standing tasks
SCENARIO 4 Above a stairwell or walkway, or where height is required for walking underneath

CARE AND CLEANING

We recommend cleaning with a soft dry cloth. Do not use abrasive materials as these will damage the finish of the product. Do not expose any part of the bulb or pendant to water or moisture.

WARRANTY AND AFTER-CARE

This product is covered by a three year warranty. Within this time, we will replace any parts that show functional defects or malfunctions. Please report any signs of fault or damage to our Customer Service team, along with supporting visual evidence, by emailing: customerservice@tala.co.uk.