cecotec 5500 Energy Silence Pure Tech Instruction Manual

ENERGYSILENCE 5500 PURE TECH
Climatizador evaporativo 3 en 1/ 3-in-1 evaporative cooler
Instruction manual

SAFETY INSTRUCTIONS

Read these instructions thoroughly before using the product.
Keep this instruction manual for future reference or new users.

• All safety instructions must be closely followed when using the appliance.

• This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory, or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children must not play with the appliance.
  Cleaning and user maintenance should not be carried out by unsupervised children.

• Do not leave the appliance unattended while in use. Unplug it from the power supply when you finish using it and before leaving the room.

• Do not try to repair the product by yourself. Contact the official Technical Support Service of Cecotec.

• Always turn off and unplug the appliance when not in use, before moving it to a new location, and before assembling or disassembling it.

• After filling the water tank, do not tilt the appliance to the sides or shake it during transport.

• Make sure that the mains voltage matches the voltage stated on the rating label of the appliance and that the wall outlet is grounded.

• Do not immerse the cord, plug, or any non-removable part of  the appliance in water or any other liquid. Do not expose the electrical connections to water. Make sure your hands are dry before handling the plug or switching on the appliance.

• Never immerse the appliance in water. Do not touch the water!

• Check the power cord regularly for visible damage. If the cord is damaged, it must be repaired by the official Technical Support Service of Cecotec to avoid any type of danger.

• Do not move the product or pull from its power cord. Do not use the power cord as handle. Do not push the cord against corners or sharp edges. Do not pass the product over the power cord. Keep the cord away from hot surfaces.

• Do not operate the product if its cord, plug, or body show visible damage, do not operate properly, or have been dropped.

• Do not use the appliance in confined spaces with explosive or flammable vapours.

• Keep the evaporative cooler away from heat sources.

• Do not leave the appliance unattended while in use. Unplug it from the power supply when you finish using it and before leaving the room.

• Do not try to repair the product by yourself. Contact the official Technical Support Service of Cecotec.

• Always turn off and unplug the appliance when not in use, before moving it to a new location, and before assembling or disassembling it. To avoid tripping hazards, wind the cord safely.

• To ensure the correct operation of the device, cleaning and maintenance tasks must be carried out according to this instruction manual. Always turn off and unplug the appliance before cleaning.

• Cleaning and maintenance tasks should not be carried out by children.

• Store the appliance and its instruction manual in a safe and dry place when not in use.

• Do not place any object in the air inlet or outlet of the evaporative cooler.

• Keep the air inlet and outlet free from obstructions.

• When moving the product, make sure that it is in an upright position.

• Do not install or use the evaporative cooler in the bathroom or other humid environments.

• Do not use sprays, insecticides, or other flammable substances near the evaporative cooler.

• If the cord is damaged, it must be replaced by the official Technical Support Service of Cecotec to avoid any type of danger.

• Do not cover the inlet and outlet of the appliance.

• Keep the air inlet away from walls, curtains, etc. to avoid blocking the air flow and adversely affecting the proper operation of the appliance.

• Do not use the product outdoors, next to a toilet, shower, or pool.

• When the product is in operation, never put your hands or any other part of your body inside the appliance. Pay special attention to children.

• Do not place any object on top of the product.

PARTS AND COMPONENTS

Fig. 1

1. Dust filter
2. Cooling pad
3. Rear part
4. Handle
5. Control panel
6. Air outlet
7. Wheels
8. Water tank
9. Ice tank
10. Remote control

Control panel. Fig. 2
Touch icons

1. ON/OFF

2. Speed

3. Mode

4. Timer

5. Oscillation

6. Cold

7. Ionisation
   Indicators

8. Timer

9. High

10. Medium speed

11. Low speed

12. Ioniser

13. Cold

14. Oscillation

15. LED display

16. Eco mode

17. Sleep mode

18. Normal mode

Note: The graphics in this manual are schematic representations and may not exactly match the product.

BEFORE USE

• This appliance is packaged in a way as to protect it during transport. Take the appliance out of its box and remove all packaging materials. You can keep the original box and other packaging elements in a safe place. This will help you prevent product damage when transporting it in the future. In case the original packaging is disposed of, make sure all packaging materials are recycled accordingly.
• Make sure all parts and components are included and in good conditions. If any of them are missing or not in good condition, please contact Cecotec’s official Technical Support Service immediately.

Box contents

• EnergySilence 5500 PureTech evaporative cooler
• Remote control
• Instruction manual

Assembling the evaporative cooler

1. Remove the packaging carefully so as not to damage the plastic main body with scissors or a knife.
2. Installing the wheels: fit the 4 wheels into the holes at the base of the cooler. Firmly insert the wheels into the body of the cooler.
3. Place the appliance on a stable, horizontal base, keeping it away from sources of radiant heat and open flames.
4. Water filling: turn the water-tank lock to the horizontal position, remove the water tank, insert the ice bricks, and fill the tank with clean tap water. Make sure that the water level does not exceed the “MAX” mark on the back of the tank.
5. Push the water tank until it clicks into place and turn the tank lock to the vertical position.

OPERATION

Using the evaporative cooler
Plug the power cord into the outlet. The LED display showing the room temperature will light up and the cooler will enter Standby mode. Modes and functions of the appliance can be toggled via the control panel or remote control.

1. Press the ON/OFF button on the control panel or remote control to turn the appliance on or off. The cooler will start at low speed and with a normal air setting. To return to Standby mode, simply press the ON/OFF button on the control panel or remote control.

2. Speed: there are three air-speed modes (low – medium – high) selectable by pressing the Speed button. Each time the Speed button is pressed, an icon appears on the LED display indicating the current speed level.

3. Mode: press the Mode button to select the type of air. Each time this button is pressed, an indicator lights up on the display to indicate the type of air. There are 3 air types: Normal–Natural–Sleep.

4. Timer: press the Timer button to set the operating time of the cooler between 0 and 12 hours; the cooler will go into Standby mode after the pre-set time has elapsed.
   Each time the button is pressed, the hours will increase one by one and the time indicator will light up on the display.

5. To reset the timer, simply press the button until the time indicator shows “00”.

6. Oscillation: press the Swing button to change the wind direction. The oscillation icon will appear on the display when the function is activated. Press the button again to stop oscillation. The vertical direction of air flow can be adjusted manually by directing the outlet grilles up and down.

7. Cool: to activate the air-cooling function, press the Cool button. The water pump will take water from the tank and pour it into the cooling pad. The cooling pad absorbs heat from the water and the evaporated air is expelled with the help of a fan. The cool breeze from the cooler lowers the temperature and generates a relaxing cooling effect.

WARNING : if the water level is low or the tank is empty, do not activate the Cool function.
Check the water level and add more if necessary. Replace old water with fresh water. It is recommended to replace the water in the tank at least once a week.
Ioniser
Press the Ion button to activate the ionising function. The ion icon on the display will light up and negative ions will be released. Ions attract small particles in the air, such as dust, pollen, mould spores, etc., making them too heavy to hover. This ensures cleaner and purer air in the environment.
Remote control
The remote control requires a button battery CR2025. Before use, remove the button-battery protector from the battery slot.
Water tank
Check the water level in the tank regularly. Make sure that the water does not exceed the MAX.
mark on the water tank. Activating the Cool function with little water in the tank may cause the water pump to malfunction and void the product warranty.
Before refilling the water tank, turn off the appliance by pressing the switch on the rear panel and unplug the power cord.
Filling up the water tank

• Remove the water tank, located at the bottom rear of the evaporative cooler, and fill it up one third of its capacity. Please note the water-level indicator when filling the tank.
• The water level in the tank must not exceed the “MAX” mark.
• The water level in the tank must be above the “MIN” mark.
• The ice bricks are placed in the water tank for cold air.

CLEANING AND MAINTENANCE

• After prolonged operation, dust accumulated on the dust filter or cooling pad may affect the air inlet. It is therefore recommended to clean the cooler regularly. Follow theinstructions below to clean the device.
• Switch off the appliance and unplug it before cleaning and maintenance.
• Use a soft, damp cloth to clean the surface of the device. Do not use abrasive or corrosive products.
• Do not immerse any part of the air cooler in water or other liquids.
• After cleaning, carefully dry the appliance and make sure that all the electrical parts are completely dry.
• Make sure the air inlet and outlet are clean and protected from dust and dirt.
• If the product is not going to be used for a long period, unplug it and store it in a dry and safe place.
• Clean the appliance at least once a week.

Dust filter
To remove the dust filter, remove the screw first, then simply press the latches with both hands and pull out the filter. Use a neutral cleaning agent and a brush to clean dust and dirt from the filter. To reinstall the cleaned filter, place the lower part of the filter first and then push the upper part until it clicks into place.
Cooling pad
The cooling pad can be seen by removing the dust filter. Press the lock in the centre and gently pull the pad out. Use a clean, soft brush to remove dust and dirt from the pad. Rinse with water if necessary and allow it to air dry. Never use any chemical cleaning solution that may damage the pad.

Water tank
Turn the water tank lock to the horizontal position and pull out the tank. Use mild cleaning agents for cleaning. Wash it with water and gently push it into its housing. Turn the lock to the vertical position.
Cleaning the exterior
Clean the exterior of the cooler with a soft, damp cloth, except for the control panel. Never use cleaning agents that could damage the exterior. Make sure that the appliance is dry before switching it on.
WARNING: Never allow water to wet the control panel. Always clean the cooler with a soft, dry cloth.

TECHNICAL SPECIFICATIONS

• Product: EnergySilence 5500 Pure Tech
• Product reference: 05876
• Nominal voltage: 220-240 V~
• Rated frequency: 50 Hz
• Power: 80 W
• Water-tank capacity: 12 l

C/ de la Pinadeta s/n, 46930
Quart de Poblet, Valencia (Spain)

Technical specifications may change without prior notice to improve product quality.
Made in China | Designed in Spain

DISPOSAL OF OLD ELECTRICAL AND ELECTRONIC APPLIANCES

This symbol indicates that, according to the applicable regulations, the product and/or cells must be disposed of separately from household waste. When this product reaches the end of its shelf life, you should dispose of the batteries/accumulators and take them to a collection point designated by the local authorities.
Consumers must contact their local authorities or retailer for information concerning the correct disposal of old appliances and/or their batteries.
Compliance with the above guidelines will help protecting the environment.

TECHNICAL SUPPORT AND WARRANTY

Cecotec shall be liable to the end user or consumer for any lack of conformity that exists at the time of delivery of the product under the terms, conditions, and deadlines established by the applicable regulations.
It is recommended that repairs are carried out by qualified personnel.
If at any moment you detect any problem with your product or have any doubt, do not hesitate to contact Cecotec’s official Technical Support Service at +34 963 210 728.

COPYRIGHT

The intellectual property rights over the texts in this manual belong to CECOTEC INNOVACIONES, S.L. All rights reserved. The contents of this publication may not, in whole or in part, be reproduced, stored in a retrieval system, transmitted, or distributed by any means (electronic, mechanical, photocopying, recording or similar) without the prior authorization of CECOTEC INNOVACIONES, S.L.

www.cecotec.es
Cecotec Innovaciones S. L.
C/de la Pinadeta s/n, 46930
Quart de Poblet, Valencia, Spain
EA01221111

Documents / Resources

| cecotec 5500 Energy Silence Pure Tech [pdf] Instruction Manual
5500 Energy Silence Pure Tech, 5500, Energy Silence Pure Tech, Silence Pure Tech, Pure Tech, Tech
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>