AGJ 8210 Wireless Transmission System Transmitter Instruction Manual
- September 27, 2024
- AGJ
Table of Contents
8210T Transmitter Operational Instructions
1. UI description
①.Toggle switch，3 gears，LOCK/ON/OFF.
②.Charging indicator lamp，charging red light,fully charged blue light.
③.Φ3.5 external micphones jack.
④.MUTE key:
1).Press the ④ MUTE key 2 seconds to mute and display .
2).Press the ④ MUTE key 2 seconds again to return and display .
⑤.PAIR key:
1).The transmitter is unlocked，press the ⑤ PAIR key 3 seconds into code
matching.
2).The transmitter is unlocked，press the ⑤ PAIR key again to return.
⑥.CHANNEL / key:
1).The transmitter is unlocked，press the ⑥ CHANNEL key to change the channel
-1.
2).The transmitter is unlocked，press the ⑥ CHANNEL key to change the channel
+1.
⑦.LCD display description
1).Channel icon： ，the transmitter is working，display the Channel 01-50 .
2).Battery indicator icon: .
3).Mute icon: / .
4).Lock icon: .
⑧.Charging contact point.
⑨.Type-C USB charging interface.
2. Operational Instructions
1). Manual mode
a. Push the toggle switch to ON, turn on the transmitter 8210T.Press the ⑥
CHANNEL / key to change the channel -1/+1,such as .
b. Push the toggle switch to ON, turn on the transmitter 8210R.Press the ⑥
CHANNEL / key to change the channel -1/+1,such as .
c. After the setup is complete,8210T plug in the external micphone to
speak，8210R plug in the external speaker to listen .
2). Automatic mode
a. Push the toggle switch to ON, turn on the transmitter 8210T.Press the ⑥
CHANNEL / key to change the channel -1/+1,such as .Press the ⑤ PAIR key 3
seconds into code matching, the receiver can search the transmitter and change
the channel into the same as the transmitter, such as .Press the ⑤ PAIR key
again to return.
b. After the setup is complete,8210T plug in the external micphone to
speak，8210R plug in the external speaker to listen .
FCC Caution:
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
IMPORTANT NOTE:
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>