BlueBuilt 935001 Monitor Arm with Mechanical Spring for 2 Monitors User Manual

: May 15, 2024
: bluebuilt

Table of Contents

BlueBuilt 935001 Monitor Arm with Mechanical Spring for 2 Monitors
Monitor Arm with Mechanical Spring for 2 Monitors

BlueBuilt 935001 Monitor Arm with Mechanical Spring for 2 Monitors

Product Specifications

Product Name: Monitor Arm with Mechanical Spring for 2 Monitors
Model Number: 935001 – BBMAG2M Version: V1.1
Mounting Options: Clamp mount (A) and Feed-through mount (B)
Desk Thickness Compatibility: Suitable for desks between 10 and 80 millimeters thick

Clamp Mount Installation
Clamping Attachment
Remove the cover from the base. Place the connection angle on the base and tighten the bolts.

Determine Desk Thickness
Depending on the desk thickness, place the desk clamp in the top or bottom holes and tighten the bolts.

Secure Clamp to Desk
Place the clamp on the desk and turn the screw upwards to firmly secure the base.

Monitor Arm with Mechanical Spring for 2 Monitors

Clamp mount (A)
Mount your monitor arm to your desk with the clamp.
Feed-through mount (B)
Drill a hole in your desk and feed the clamp through it.

SET UP MONITOR ARM.

A helping hand.

BlueBuilt-935001-Monitor-Arm-with-Mechanical-Spring-
for-2-Monitors-2 In the box:

Swivel arms
Lift arms
VESA plates
Base
Clamp
Clamp attachment
Mounting plate
Screw
Screws
Hex keys 4mm and 5mm
Screws and washers
From your own toolbox:
Screwdriver
Electric drill

CHECKLIST.
Does the tick.

Check the VESA size of your monitor. Then you know whether it fits on the monitor arm. The screw holes must match between the VESA plate and your monitor.

Do you have a question?
Coolblue.nl/en/ customer-service

Coolblue is not liable for any injury, damage or bickering with your friend caused by an incorrect installation.

Suitable for desks between 10 and 80 millimetres thick.
Remove the cover from the base 4 . Place the connection angle 6 on the base and tighten the bolts 9 .
Determine the thickness of your desk. Depending on this, place the desk clamp 5 in the top or bottom holes and tighten the bolts 9 .v
Place the clamp on the desk and turn the screw upwards so that the base is firmly secured.
Place the swivel arms 1 on the base. Tighten the screws as desired. The tighter you go, the less smooth the arms will move.
Place the lift arms 2 . Tighten the screws as desired.
Place the VESA plates 3 on the monitor arm and tighten the bolts 8 .
Place your monitor on a cloth and place the top screws 11 in the monitor. Use the washers 11 as an option for extra reinforcement.
Slide the monitors onto the VESA plates and screw the lower screws 11 into the monitor.
Slide the cable tray upwards to open it. Use this to conceal your monitor cables and close it again.

BlueBuilt-935001-Monitor-Arm-with-Mechanical-Spring-
for-2-Monitors-7

Suitable for desks between 10 and 45 millimetres thick.
Unscrew the disc from the clamp 5 and unscrew the connection angle 6
Drill two 10-millimetre holes through your desk.
Place the fixing plate 7 around the feed-through. Then screw it through the hole into the base until it is firmly secured.