Astrogate AP2-11 Astros Pod User Manual

ASTROS POD
AP2-11 / AP2-12
User Manual
Astrogate Inc.

What’s in the box

1. Single package or Dual package
   • Single package
   • Dual package

2. Quick Start Guide

ASTROS Pod overview
LED
Share Button
Function Button
USB-C, Power Rating: 5V 900mA

How to start using ASTROS Pod

1. Pair your Pod with an ASTROS Station
   Step 1.
   Connect the Pod to the USB-C on the well-configured Station front panel to start pairing mode.
   Step 2.
   LED breathing green: pairing
   LED steady green: pairing finished
   You may check the main screen message for pairing status.
   Step 3.
   When ‘Pairing finished’ appeared on the main screen, you may disconnect your Pods from the Station.

2. Start the presentation
   Step 1.
   Connect the Pod to your laptop’s USB-C port and wait until the LED remains light blue. If LED is pink, your device does not support USB-C A/V output.
   Step 2. For AP2-11
   The Pod will automatically start screen sharing when ready.
   Disconnect the Pod if you wish to stop sharing.
   Long press the Share Button to switch between full-screen and split-screen.
   Step 2. For AP2-12 Single click the Share button to start or stop screen sharing Long press the Share Button to switch between full-screen and split- screen.

LED color definition

Please pair with the Station again
Amber| Connection| Station connection failed or disconnected
Please replug the Pod
Pink| Connection| USB-C doesn’t support A/V output

Federal Communications Commission (FCC) Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with  the instructions, may cause harmful interference to radio communications. However, there isno guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or  more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

IMPORTANT NOTE:
This device has been tested with 5mm separation distance SAR, and it is compliant with the general population/uncontrolled RF exposure limit.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>